Sharp CD SW340 - Manual (Page 27)

03/12/17 CD-SW340 02-43.fm
27
CD-SW340
Radio
Memorizing a station
You can store 40 AM and FM stations in memory and recall them at
the push of a button. (Preset tuning)
Note:
The backup function protects the memorized stations for a few
hours should there be a power failure or the AC power cord
become disconnected.
To recall a memorized station
To scan the preset stations
The stations saved in memory can be scanned automatically.
(Preset memory scan)
To erase entire preset memory
1 Perform steps 1 - 3 in “Tuning” on page 26.
2 Press the MEMORY button on remote control to enter the
preset tuning saving mode.
3 Within 30 seconds, press the PRESET ( or ) button to
select the preset channel number.
Store the stations in memory, in order, starting with preset
channel 1.
4 Within 30 seconds, press the MEMORY button on remote
control to store that station in memory.
If the “MEMORY” and preset number indicators disappear
before the station is memorized, repeat the operation from step
2.
5 Repeat steps 1 - 4 to set other stations, or to change a
preset station.
When a new station is stored in memory, the station previously
memorized for that preset channel number will be erased.
Press the PRESET ( or ) button for less than 0.5 seconds to
select the desired station.
1 Press the PRESET ( or ) button for more than 0.5 seconds.
The preset number will flash and the programmed stations will be
tuned in sequentially, for 5 seconds each.
2 Press the PRESET ( or ) button again when the desired
station is located.
1 Press the ON/STAND-BY button to enter the stand-by mode.
2 While pressing down the button and the button, press
the TUNER (BAND) button until “TUNER CL” appears.
TIMER
CD
4
5
3
2 1
TUNER
(BAND)