beautypg.com

Specifications, General – JVC KD-LH2000R User Manual

Page 57

background image

57

ENGLISH

SPECIFICATIONS

GENERAL

Power Requirement:

Operating Voltage: DC 14.4 V

(11 V to 16 V allowance)

Grounding System: Negative ground
Allowable Operating Temperature: 0°C to +40°C
Dimensions (W

× H × D):

Installation Size: 182 mm

× 52 mm × 150 mm

Panel Size: 188 mm

× 58 mm × 14 mm

Mass: 1.4 kg (excluding accessories)

Design and specifications are subject to change
without notice.

AUDIO AMPLIFIER SECTION

Maximum Power Output:

Front:

50 W per channel

Rear:

50 W per channel

Continuous Power Output (RMS):

Front:

19 W per channel into 4

Ω, 40 Hz

to 20 000 Hz at no more than
0.8% total harmonic distortion.

Rear:

19 W per channel into 4

Ω, 40 Hz

to 20 000 Hz at no more than
0.8% total harmonic distortion.

Load Impedance: 4

Ω (4 Ω to 8 Ω allowance)

Equalizer Control Range:

Low:

±06 (50 Hz, 80 Hz, 120 Hz)

Mid:

±06 (700 Hz, 1 kHz, 2 kHz)

High:

±06 (8 kHz, 12 kHz)

Frequency Response: 40 Hz to 20 000 Hz
Signal-to-Noise Ratio: 70 dB
Line-Out Level/Impedance: 2.0 V/20 k

Ω load

Output Impedance: 1 k

TUNER SECTION

Frequency Range:

FM:

87.5 MHz to 108.0 MHz

AM:

(MW) 522 kHz to 1 620 kHz
(LW)

144 kHz to 279 kHz

[FM Tuner]
Usable Sensitivity: 11.3 dBf (1.0

µV/75 Ω)

50 dB Quieting Sensitivity: 16.3 dBf (1.8

µV/75 Ω)

Alternate Channel Selectivity (400 kHz): 65 dB
Frequency Response: 40 Hz to 15 000 Hz
Stereo Separation: 30 dB
Capture Ratio: 1.5 dB

[MW Tuner]
Sensitivity: 20

µV

Selectivity: 35 dB

[LW Tuner]
Sensitivity: 50

µV

CD PLAYER SECTION

Type: Compact disc player
Signal Detection System: Non-contact optical

pickup (semiconductor laser)

Number of channels: 2 channels (stereo)
Frequency Response: 5 Hz to 20 000 Hz
Dynamic Range:

96 dB

Signal-to-Noise Ratio: 98 dB
Wow and Flutter: Less than measurable limit
MP3 recording format: MPEG 1/2 Audio Layer 3
Max. Bit Rate: 320 Kbps

Available characters

You can use the following characters to assign
names to CDs, and external components (see
page

42

).

In addition, these characters are

used to display the information such as RDS,
ID3v1 tags, DAB, and so on.

Accented letters

Capital

Small

Numbers and symbols

EN54-57LH2000R[E]f.pm5

02.3.29, 4:27 PM

57