JVC CA-MD70 - Manual (Page 15)

– 9 –
English
AM EXT
AM LOOP
FM 75 COAXIAL
GND
IN (PLAY)
OUT (REC)
DIGITAL IN
OPTICAL
LEFT
RIGHT
LEFT
RIGHT
LEFT
RIGHT
LEFT RIGHT
127V 110V
220V
230 –
240V
LINE VOLTS
NOW, you can plug in the unit and other connected
equipment FINALLY!
To a wall outlet
To audio output
To optical digital output
Protective plug
To connect audio equipment with an optical digital
output terminal
By using both an optical digital cord (not supplied) and an
audio cord (not supplied), connect:
• Between the optical digital output terminal on the other
equipment and the AUX DIGITAL IN OPTICAL
terminal.
• Between the audio output jacks on the other equipment
and the AUX jacks.
Before connecting the other equipment,
remove the protective plug from the terminal.
Audio equipment with an
optical digital output
IN (PLAY)
OUT (REC)
DIGITAL IN
OPTICAL
LEFT
RIGHT
LEFT
RIGHT
LEFT
RIGHT
LEFT RIGHT
When connecting the AC power cord into a wall outlet, the
unit automatically starts display demonstration.
To stop the display demonstration, press any button on
the unit or the remote control.
If the wall outlet does not match the AC plug, use the
supplied AC plug adaptor.
Use a screwdriver to rotate the voltage selector so the
voltage number the arrow is pointing at is the same as the
voltage where you are plugging in the unit.
DO NOT plug in before setting the voltage selector
switch on the rear of the unit and all connection
procedures are complete.
Voltage selector
Adjusting the Voltage Selector
Before plugging in the unit, set the correct voltage for your
area with the voltage selector on the rear of the unit.
AM EXT
P
FM
75
COAXIAL
127V
110V
220V
230 –
240V
LINE VOLTS
Continued
EN01-14.CA-MD70[U] 98.11.18, 3:15 PM 9