JVC CA-MD70 - Manual (Page 13)

– 7 –
English
1
Connect the AM loop antenna to the AM LOOP
terminals as illustrated.
2
Turn the AM loop antenna until you have the best
reception.
To connect an outside AM antenna
When reception is poor, connect a single vinyl-covered
wire to the AM EXT terminal and extend it horizontally.
(The AM loop antenna must remain connected.)
For better reception of both FM and AM
• Make sure the antenna conductors do not touch any other
terminals and connecting cords.
• Keep the antennas away from metallic parts of the unit,
connecting cords, and the AC power cord.
Continued
AM antenna
Vinyl-covered wire
(not supplied)
AM loop antenna (supplied)
Connecting Speakers
You can connect the speakers using the speaker cords.
Right speaker Left speaker
Black
Red
1
Twist the core of the cord at the end of
each cord, then remove the insulation.
2
Open the speaker terminal.
3
Insert the end of the speaker cord to the terminal.
Match the polarity of the speaker terminals: Red (+) to
red (+) and black (–) to black (–).
4
Close the speaker terminal on the rear of the unit.
Use only speakers with the same speaker impedance as
indicated by the speaker terminals on the rear of the unit.
Speaker cord
Speaker cord
AM EXT
AM
LOOP
FM
75
COAXIAL
GND
ANTENNA
RIGHT LEFT
SPEAKERS
2 3, 4
EN01-14.CA-MD70[U] 98.11.18, 3:14 PM 7