JVC GR-D850AA - Manual (Page 15)

EN
15
MasterPage: Start_Right
Recording & Playback
EN
G
L
ISH
During recording, a time code is recorded on
the tape. This code is to confirm the location of
the recorded scene on the tape during
playback.
1 , 3, & 4, time code begins counting from
“00:00:00” (minute:second:frame).
2
, time code continues from the last time
code number.
If during recording a blank portion is left
partway through the tape, the time code is
interrupted. When recording is resumed, the
time code starts counting up again from
“00:00:00”.
To prevent this, perform “Recording from the
middle of a tape” ( ੬ 15) in the following cases;
● When shooting again after playing back a
recorded tape.
● When power shuts off during shooting.
● When a tape is removed and re-inserted during
shooting.
● When shooting using a partially recorded tape.
● When shooting again after shooting a scene
then opening/closing the cassette holder cover.
Notes:
● The time code cannot be reset.
● During fast-forwarding and rewinding, the time
code indication does not move smoothly.
● The time code is displayed only when “TIME
CODE” is set to “ON” ( ੬ 20).
Recording from the middle of a tape
Playback a tape or use Blank Search
( ੬ 17) to find the spot at which you want to
start recording, then engage the Still
Playback mode (
੬ 16).
Set the Power Switch to “REC” ( ੬ 9), then
start recording.
Auto/Manual Mode
Time Code
Press AUTO button repeatedly to switch to
auto/manual recording mode. When manual
mode is selected, the indicator “M” appears
on the LCD monitor.
Auto Mode : A
You can record using no special effects or
manual adjustments.
Manual Mode : M
Recording is possible by setting various
functions manually.
M
1 2 : 3 4 : 24
1 2 3 4
Minutes
Seconds
Frames
(25 frames =
1 second)
Recording Portion
Blank Portion
Recording Start Point
recorded tape
Display
1
2
GR-D850AA_EN.book Page 15 Thursday, October 18, 2007 5:26 PM