JVC SR-V10U - Manual (Page 9)

EN
9
INFORMATION
● If “AUTO CLOCK” is set to “ON” on the Clock Set screen on page 11, the clock will be adjusted automatically by the host
channel every hour (except 11:00 PM, midnight, 1:00 AM and 2:00 AM) using the incoming PBS channel clock setting data.
(This automatic clock adjustment can only be performed when the VCR is turned off. The clock will be adjusted just on these
hours — on the time displayed on the front display panel, not on the actual real time.)
The default setting of “AUTO CLOCK” is “ON”.
● If the memory backup fails, because a power outage occurs or because the AC power cord is unplugged, Plug & Play will be
performed when power is restored to the VCR.
● Poor antenna or cable signal may prevent the VCR from receiving the Auto clock setting data from the PBS channel. If this
function is taking a considerable amount of time, it may be necessary to perform the Semiauto or Manual Clock Set
procedure.
What to do if Plug & Play setting failed
● If an incorrect time is displayed on the front display panel, you may be receiving the clock setting data of a PBS channel from
an adjacent time zone, or an incorrect PBS channel from a cable TV system. In this case, perform the Semiauto ( ੬ pg. 11) or
Manual Clock Set ( ੬ pg. 12) procedure.
● If “- -:- -” appears on the front display panel, your antenna cable may not be connected to the VCR or there may not be a Host
PBS signal available in your area. Ensure that the antenna cable is connected correctly. Then turn on and off the VCR; the Plug
& Play setting will be automatically reactivated.
If Plug & Play setting is not performed though the antenna cable is connected correctly, perform Manual Clock Set (
੬ pg. 12)
and Auto Channel Set or Manual Channel Set ( ੬ pg. 13 or 14).
Last-Function Memory
When the AC is removed from the VCR or when the power failure occurs, your settings for the following functions
are kept in memory. These settings will resume when the VCR is turned on again.
a- Input Selection (channel or auxiliary input; L-1 or F-1)
b- Recording tape speed (
੬ pg. 19)
c- “ON SCREEN (REC)” (
੬ pg. 37, 38)
d- “ON SCREEN (PLAY)” ( ੬ pg. 37, 39)
e- “RETURN POINT” ( ੬ pg. 37, 41)
f- “DAY/TIME INSERT” ( ੬ pg. 37, 41)
g- “REC SAFETY” ( ੬ pg. 37, 41)