JVC G2000 - Manual (Page 56)

54
Operating the Main Menu (Cont.)
Changing Channels
OPERATE
VOL.
PAGE
BACK
PRESET
ZOOM FOCUS
COMPUTER VIDEO
QUICK
ALIGN. AV
MUTING
W
T
MENU/ENTER
MENU/ENTER
button
Cursor buttons
PAGE BACK button
■ Remote control unit
You can changing channels where lines and sources have been set
up. The channels can be switched by using either a “direct channel”
or the “Channel setup/selection” menu.
■ To changing channels using a “Direct
Channel” :
1 Press the PAGE BACK when no menu
is displayed.
• The channel number is shown on the upper part of the screen.
• A channel number which has a line and source registered is
displayed. (If no channel that has such registration is available,
AUTO will be displayed.)
C H : 1
(Direct Channel switching menu)
2 Select the Channel number with the
cursor button
5
or
∞
.
• Numbers that you can choose from are numbers from 1 to 10
and AUTO.
• Pressing the cursor ∞ makes the number smaller.
• Pressing the cursor 5 makes the number larger.
• If you press PAGE BACK, the selection will be canceled.
3 Press the MENU/ENTER button to set
(fix).
• The display switches automatically to the line and source that
are set for the channel.
Y / C
C H : 1
N T S C ( 4 8 0 i )
Line
Source
Channel
• If you select AUTO and press MENU/ENTER to set, the source
will be set up in “AUTO” mode.
Memo
• When AUTO is selected, all sources will become candidates to be
displayed.
• When a channel is selected, the source registered to the selected channel
is to be displayed.
• If the source being input is not registered (set up) to the channel selected,
a “?” mark is put prior to the source name.
C O M P 2
C H : 1
? N T S C ( 4 8 0 i )
Line
Source
Channel
G2000 p.35-59 99.11.20, 3:29 AM 54