Speakers – JVC CA-DXU20 User Manual

Page 8

Speakers

To connect the speaker cords

• When connecting the speaker cords, match their polarity

with that of the speaker terminals: blue/red/green/white to
(+) and black to (–).

For CA-DXU20

For CA-DXU9

• Use only speakers with the same speaker impedance as

indicated by the speaker terminals on the rear of the System.

• The front and center speakers and subwoofer(s) are

magnetically shielded to avoid color distortions on TVs.
However, if not installed properly, it may cause color
distortions. So, pay attention to the following when
installing the speakers.
– When placing the speakers near a TV set, turn off the TV’s

main power switch or unplug it before installing the
speakers.
Then wait at least 30 minutes before turning on the TV’s
main power switch again.

Some TVs may still be affected even though you have
followed the above instruction. If this happens, move the
speakers away from the TV.

1Push

2Insert

3Release

From front right speaker (black/blue)

From front left speaker (black/blue)

From surround
left speaker
(black/white)

From surround right
speaker (black/white)

From center speaker (black/green)

From right subwoofer
(black/red)

From left
subwoofer
(black/red)

From front right speaker (black/blue)

From front left speaker (black/blue)

From surround
left speaker
(black/white)

From surround right
speaker (black/white)

From center speaker (black/green)

From subwoofer
(black/red)

• DO NOT connect more than one speaker to

each terminal.

• DO NOT push or pull the speakers as this

will damage the foot spacers at the bottom
of the speakers.

Speaker layout
To enjoy multi-channel sound, locate the speakers as
follows. If you cannot locate like this, adjust the speaker
setting by using the SPK. SETTING menu (see page 45).

For CA-DXU20

For CA-DXU9

Center speaker

Front right
speaker

Front left
speaker

Subwoofer

Surround left speaker

Surround right speaker