JVC 0405MWMMDWBET - Manual (Page 13)

10
Common Operations
Turning On or Off the Power
To turn on the unit, press STANDBY/ON (or
on the unit) so that the STANDBY lamp goes
off.
To turn off the unit (on standby), press
STANDBY/ON
(or on the unit) again
so that the STANDBY lamp lights up.
A little power is always consumed even while
the unit is on standby.
To switch off the power supply completely, unplug the AC
power cord from the AC outlet.
When you unplug the AC power cord or if a power
failure occurs
The clock is reset to “0:00” right away, while the tuner preset
stations (see page 13) will be erased in a few days.
Setting the Clock
Before operating the unit any further, first set the clock built
in this unit. You can set the clock whether the unit is on or
off.
On the remote control ONLY:
1
Press CLOCK/TIMER.
The hour digits start flashing on the display.
2
Press
¢ or 4 to adjust
the hour, then press SET/
RESUME.
The minute digits start flashing on
the display.
• If you want to correct the hour after pressing SET/
RESUME, press CANCEL. The hour digits start
flashing again.
3
Press
¢ or 4 to
adjust the minute, then
press SET/RESUME.
To check the clock time
Press DISPLAY while playing any source.
• To return to the source indication, press
DISPLAY again.
While the time indication appears on the display
If you press a button or turn a control, the time indication returns to
the source indication.
To adjust the clock again
1 Press CLOCK/TIMER repeatedly until
“CLOCK” is selected.
• Each time you press the button, the clock/
timer setting modes change as follows:
2 Press SET/RESUME.
3 Perform steps 2 and 3 of “Setting the Clock.”
When you unplug the AC power cord or if a power
failure occurs
The clock loses the setting and is reset to “0:00.” You need to set the
clock again.
Selecting the Sources
To listen to the radio, press FM/AM. (See page 13.)
To play back CDs, press CD
6 or CD1, CD2, CD3. (See
pages 14 – 19.)
To select the external equipment as the source,
press AUX/USB. (See pages 8 and 9.)
When you press the play button for a particular source
(FM/AM, CD
6, and AUX/USB), the unit turns on and the
unit starts playing the source if it is ready.
• The selected source lamp lights up.
Continued
ON TIME DAILY
CLOCK Canceled
MXGC5[A]_10-11.p65 05.4.13, 5:11 PM 10