Jenn-Air 720-0511 User Manual
Jenn-Air Grills
This manual is related to the following products:
Table of contents
Document Outline
- COVER PAGE 10.3.07.doc
- TABLE OF CONTENT 10.3.07.doc
- PAGE 1-2 10.3.07.doc
- PAGE 3 10.3.07.doc
- PAGE 4 10.3.07.doc
- PAGE 5 10.3.07.doc
- PAGE 6 10.3.07.doc
- PAGE 7 10.3.07.doc
- PAGE 8 10.3.07.doc
- PAGE 9 10.3.07.doc
- PAGE 10-12 10.3.07.doc
- LIQUID PROPANE CYLINDER REQUIREMENTS
- (20 lb. Cylinder)
- GENERAL
- It is handy to keep a spray bottle of soapy water near the shut-off valve of the gas supply line. Spray all the fittings. Bubbles indicate leaks.
- Disconnected liquid propane cylinders must have threaded valve plugs tightly installed, and must not be stored in a building, garage or any other enclosed area.
- The gas must be turned off at the supply cylinder when the unit is not in use.
- If the appliance is stored indoors, the cylinder must be disconnected and removed from the appliance.
- Cylinders must be stored outdoors in a well-ventilated area out of the reach of children.
- It is handy to keep a spray bottle of soapy water near the shut-off valve of the gas supply line. Spray all the fittings. Bubbles indicate leaks.
- PAGE 13-14 10.3.07.doc
- WARNING
- The rotisserie motor is equipped with a plug and should be plugged directly into a properly grounded receptacle in accordance with local codes or, in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70, or the Canadian Electrical Code, CSA C22.1. DO NOT cut or remove the grounding prong from this plug.
- Keep the rotisserie motor cord away from the heated surfaces of the grill. When not in use remove and store the motor in a dry location.
- PAGE 15 10.3.07.doc
- PAGE 16-18 10.3.07.doc
- Page 19 10.3.07.doc
- Page 20 10.3.07.doc
- PAGE 21-22 10.3.07.doc
- LIGHTING INSTRUCTIONS
- MATCH LIGHTING
- STAINLESS STEEL
- GRILL RACK
- GRILL BURNERS
- WARNING
- Failure to properly place the burner over the orifice could cause a fire to occur behind and beneath the valve panel, thereby damaging the grill and making it unsafe to operate.
- GRILL BURNER REMOVAL/INSTALLATION
- The grill burners are factory installed.
- To remove the main burners for cleaning:
- 1. Locate the nut at the rear of the burner on the bottom side.
- 2. Remove the nut and lift the burner out of the fire box.
- To reinstall the main burners:
- 3. Insert the burner over the valve assembly (Item# 20 on page 24).
- 4. Insert the back of the burner into the hole at the rear of the fire box and reinstall the nut.
- 5. Make sure orifice spud is inside the burner’s venturi as shown below.
- PAGE 23 10.3.07.doc
- PAGE 24 10.3.07.doc
- PAGE 25-26 10.3.07.doc
- PAGE 27-29 10.3.07.doc
- PAGE 30-31 10.3.07.doc
- PAGE 32 10.3.07.doc