Jenn-Air 750-0165 User Manual
Stainless steel built-in gas grill
STAINLESS STEEL BUILT-IN GAS GRILL
MODEL #s: 740-0165 (LP) / 750-0165 (NG) LOWE’S ITEM #s: 144510/157618
Jenn-Air is a Trademark of the Maytag Corporation and is used under license to Lowe’s Companies, Incorporated.
FOR OUTDOOR USE ONLY
PLEASE CONTACT 1-800-554-5799 FOR ASSISTANCE
DO NOT RETURN TO PLACE OF PURCHASE
This manual is related to the following products:
Table of contents
Document Outline
- Cover page.doc
- TABLE OF CONTENT.doc
- PAGE 1-2.doc
- PAGE 3.doc
- PAGE 4.doc
- Page 5.doc
- PAGE 6.doc
- Page 7.doc
- Page 8.doc
- PAGE 9.doc
- PAGE 10.doc
- PAGE 11.doc
- PAGE 12.doc
- Page 13.doc
- PAGE 14-15.doc
- GENERAL
-
- It is handy to keep a spray bottle of soapy water near the shut-off valve of the gas supply line. Spray all the fittings. Bubbles indicate leaks.
- Disconnected liquid propane cylinders must have threaded valve plugs tightly installed, and must not be stored in a building, garage or any other enclosed area.
- The gas must be turned off at the supply cylinder when the unit is not in use.
- If the appliance is stored indoors, the cylinder must be disconnected and removed from the appliance. Cylinders must be stored outdoors in a well-ventilated area out of the reach of children.
-
- GENERAL
- PAGE 16-17.doc
- WARNING
- The rotisserie motor is equipped with a plug and should be plugged directly into a properly grounded receptacle.
- Do not cut or remove the grounding prong from this plug.
- Keep the rotisserie motor cord away from the heated surfaces of the grill. When not in use remove and store the motor in a dry location.
- PAGE 18.doc
- Page 19.doc
- PAGE 20.doc
- Page 21.doc
- STAINLESS STEEL
- GRILL RACK
- GRILL BURNERS
- GRILL BURNER REMOVAL/INSTALLATION
- The grill burners are factory installed. To remove the main burners for cleaning,
- 1. Locate the cotter pin at the rear of the burner on the bottom side.
- 2. Remove the cotter pin and lift the burner out of the fire box.
- 3. To reinstall the main burners, insert the burner over the valve assembly (See exploded view and parts list on pages 23 and 25).
- 4. Insert the back of the burner into the hole at the rear of the fire box and reinsert the cotter pin.
- GRILL BURNER CLEANING
- PAGE 22.doc
- PAGE 23.doc
- Page 24.doc
- PAGE 25.doc
- PAGE 26.doc
- PAGE 27-29.doc
- PAGE 30-31.doc
- PAGE 32.doc