JVC 1000MKV*UN*VP - Manual (Page 30)

30
EN
1
Load a tape (
੬
pg. 13).
2
Set the Power Switch to “ ”.
To start playback, press 4/6.
•To stop playback, press 5.
•Press 2 to rewind, or 3 to fast-forward the tape
during Stop mode.
NOTES:
● The camcorder shuts off automatically after about
5 minutes in Stop mode. To turn on again, set the Power
Switch to “OFF”, then to “
”.
● When the Power Switch is set to “ ” and the LCD
monitor is opened at an angle of 60 degrees or more, the
LCD monitor switches on and the viewfinder switches
off automatically to save power.
● The playback picture can be viewed in the viewfinder
(with the LCD monitor shut), on the LCD monitor or on
a connected TV (
੬
pg. 32, 33).
● You can also view the playback picture on the LCD
monitor with it flipped over and retracted.
● If a blank portion on the tape is played back, the screen
may become black. This is not a malfunction.
PLAYBACK Basic Playback
Rewind (2) Button
Fast-Forward (3) Button
Play/Pause (4/6) Button
Stop (5) Button
Power Zoom
Lever (VOL.)
BRIGHT Wheel
Set to “ ”.
Speaker
LCD Monitor Brightness Adjustment: Rotate BRIGHT towards “+” to brighten, or towards “–”
to darken.
● The Bright Level Indicator is displayed under the Date/Time Display when you play back images recorded in
Wide Mode (
੬
pg. 23).
Speaker Volume Control: Slide the Power Zoom Lever (VOL.) towards “+” to turn up the volume,
or towards “–” to turn down the volume.
● The Speaker Volume Indicator is displayed under the Date/Time Display when you play back images
recorded in Wide Mode (
੬
pg. 23).
Still Playback: Pauses during playback.
1) Press 4/6 during playback.
2) To resume normal playback, press 4/6 again.
● Noise bars will appear and the picture will become monochrome during Still Playback.
● If TBC (
੬
pg. 31) is engaged, noise bars will not appear. This mode is called Fine Still.
Shuttle Search: Allows high-speed search in either direction.
1) Press 3 for forward or 2 for reverse search during playback.
2) To resume normal playback, press 4/6.
● During playback, press and hold 2 or 3. The search continues as long as you hold the button. Once you
release it, normal playback resumes.
● Noise bars appear and pictures may become monochrome or darken during Shuttle Search. This is normal.