JVC GR-DVL1020 - Manual (Page 52)

EN
51
1
L 2
12 : 34 : 24
B I T / SOUND1 P S 4
6
12 . . 02 5 2
17 3 0 :
Playback Sound
During tape playback, the camcorder detects the sound mode in which the recording was made, and plays the
sound back. Select the type of sound to accompany your playback picture. According to the menu access
explanation on pg. 50, select “SOUND MODE” or “12BIT MODE” from the Menu Screen and set it to the desired
parameter.
Minutes
Seconds
Frames*
*25 frames = 1 second
NOTES:
●
The “SOUND MODE” setting is available for both 12-bit and 16-bit sound. (In previous models’ functions, “12-bit” is
called “32 kHz” and “16-bit” is called “48 kHz”.)
●
The camcorder cannot detect the sound mode in which the recording was made during fast-forward or rewind. During
playback the sound mode is displayed in the upper left corner.
SOUND MODE
12BIT MODE
: Factory-preset
STEREO
SOUND L
SOUND R
MIX
SOUND 1
SOUND 2
Sound is output on both “L” and “R” channels in stereo.
Sound from the “L” channel is output in stereo.
Sound from the “R” channel is output in stereo.
Original and dubbed sounds are combined and output in stereo on both
“L” and “R” channels in stereo.
Original sound is output on both “L” and “R” channels in stereo.
Dubbed sound is output on both “L” and “R” channels in stereo.
ON SCREEN setting:
For playback sound, tape
speed and tape running.
DATE/TIME setting:
For date/time. TIME CODE setting:
For time code.
Display