JVC LPT0923-001B - Manual (Page 63)

Masterpage:Right0
EN
63
Filename [DR-MH30EU_09Editing.fm]
Page 63 Tuesday, 29 June 2004 17:40
REMOTE CONTROL
Remote Control 1/2/3/4 Code Switching
The remote control is capable of controlling four JVC video units
independently. Each of the units can respond to one of four codes
(1, 2, 3 or 4). The remote control is preset to send 3 code signals
because your unit is initially set to respond to 3 code signals. You
can easily modify your unit to respond to 1, 2 or 4 code signals.
● Keep pressing SET UP down during step 1.
1
Press the number key “1” for 1, “2” for 2, “3” for 3 or “4” for 4
to change the remote control code, then press ENTER.
2
Press 1 on the unit to turn off the unit.
3
Press 4 on the unit for over 5 seconds while the unit is turned
off. The code currently set appears on the front display panel.
4
Press 8 on the remote control to change the unit’s code. The
code currently set on the remote control blinks on the front display
panel for approximately 5 seconds, and is applied to the unit.
NOTE:
When “POWER SAVE” is set to “ON” (
੬
pg. 69), it is not possible to
change the remote code.
TV Multi-Brand Remote Control
Your remote control can operate the basic functions of your TV set.
In addition to JVC TVs, other manufacturer’s TVs can also be
controlled.
IMPORTANT:
Although the provided remote control unit is compatible with JVC
televisions, as well as many other models, it may not work with your TV,
or in some instances, may have limited function capability.
● Keep pressing SET UP down during step 1.
1
Enter your TV’s brand code using the number keys, then press
ENTER.
2
Press 1 on the unit’s remote control to turn on the TV and try
operations ( ੬ step 3).
● Once you have set the remote control to operate the TV, you do not
have to repeat this step until you replace your remote control’s
batteries.
● Some brands of TVs have more than one code. If the TV does not
function with one code, try entering another.
3
Press the corresponding buttons to operate the TV: 1, TV AV/
VIDEO, PR +/–, TV% +/–, TV , number keys.
● For some brands of TVs, you must press ENTER after having
pressed the number keys.
Remote Control Functions
Slide the TV/CABLE/SAT/DVD switch to DVD.
4
1
ENTER
SET UP
8
1 – 4
CABLE/SAT
DVD TV
● Turn off the TV using its remote control.
● Slide the TV/CABLE/SAT/DVD switch to TV.
BRAND NAME CODE
JVC
HITACHI
MAGNAVOX
MITSUBISHI
PANASONIC
RCA
SHARP
SONY
SAMSUNG
SANYO
SEARS
TOSHIBA
ZENITH 01, 03
10
02
03
04, 11
05
06
07
12
13
13
08
09
TV% +/–
TV
0 – 9
TV AV/VIDEO
1
PR +/–
SET UP
ENTER
CABLE/SAT
DVD TV
DR-MH30EU_00.book Page 63 Tuesday, June 29, 2004 5:41 PM