JVC 340 SC - Manual (Page 4)

Safety
vi Model 330, 340SC, and 370SC Service Manual
must accept any interference received including interference that may cause undesired
operation.
Operation of this equipment in a residential area is likely to cause harmful interference, in
which case the user will be required to correct the interference at their own expense.
Shielded interconnect cables must be used with this equipment to insure compliance with
the pertinent RF emission limits governing this device.
Installation Safeguards
WARNING!!!
If there is any visible damage to any of the cables do
not power on the projector until the damaged cable is replaced.
CAUTION!
Place the projector on a smooth, stable and level surface
in an area free from dust and moisture. Do not place the equipment in direct
sunlight or near heat-radiating appliances. Smoke, steam and exposure to direct
sunlight could adversely affect the internal components. Avoid rough handling
when moving your equipment, as a strong shock could damage its internal
components.
CAUTION!
If installing a ceiling mount, use only parts supplied or
recommended by the manufacturer. Observe all instructions and warnings as
listed in this manual.
Projector Weight
The HJT projector and shipping container have a combined weight of either 512 (Model
330 and 340SC) or 550 (Model 370SC) pounds. The HJT shipping container weighs 170
pounds and the projector itself weighs either 342 (Model 330 and 340SC) or 380 (Model
370SC) pounds.
Do Not Tilt the Projector More Than 85 Degrees
Do not mount the projector on an excessively tilted base. The projector can be tilted a
maximum of 85 degrees. Mount it only on a stable, vibration-resistant base capable of
supporting at least three times its weight. If in doubt, contact the factory.