JVC TK-C215V4U - Manual (Page 18)

18
Installation and connection
When mounting the camera to the
electrical box
NOTE:
Before mounting the camera to electrical boxes,
please refer to local building codes for box type to
use for low-voltage wiring.
Ⅵ Connecting
1. Align j with the shooting direction when
mounting the cover to the electrical box.
2. Follow steps 2 to 7 of AWhen mounting the
camera directly to the ceiling or on the wall B
( Ⅵ Connecting) (A pg. 16).
Ⅵ Mounting
1. Attach the camera to the outer case that
has been fastened to the electrical box.
Follow steps 1 to 3 of
AWhen mounting the
camera directly to the ceiling or on the wall B
( Ⅵ Mounting) (A pg. 17)
Ⅵ Adjusting Images
After mounting is completed, adjust the
images while checking the actual image.
(
A pg. 19 AAdjusting ImagesB)
Mount by allowing the cable to exit from
the side
When mounting the camera to the ceiling or a
wall, it is possible to guide the cable from the side
without opening any holes.
The basic mounting method is identical to steps
in
AWhen mounting the camera directly to the
ceiling or on the wall B (A pg. 16).
1. Break the cable extraction hole using a
pair of long-nose pliers
2. Pull out the cable from the extraction hole
and mount it to the ceiling or wall
3. Connecting the cable
Follow steps 4 to 7 of
AWhen mounting the
camera directly to the ceiling or on the wall B
( Ⅵ Connecting) (A pg. 17)
4. Adjusting Images
After mounting is completed, adjust the
images while checking the actual image.
(
A pg. 19 AAdjusting ImagesB)
Mounting the Camera
(continued)
FRON
T
UP
Align with shooting direction
Outer case
mounting screws
Less than 4 mm
Cable
TK-C215V4_EN.book Page 18 Wednesday, June 14, 2006 8:00 PM