GE 19200 GE Portable Wireless Seven-Sound Chime - Manual (Page 2)

Battery Release Tab
2. Install 4 C-cell batteries (we recommend Alkaline Batteries)
3. Remove back of wireless push button and install the 12-volt battery
(included) as shown below.
Chime Tune Setting
All wireless chimes may have more than one push button. The chime tune for
each push button is set with jumpers 7-9.
Single Push Button Kit: If you purchased a kit with a single push button, the
chime tune will be set to Ding Dong from the factory.
Dual Push Button Kit: If you purchased a kit with two push buttons, one push
button will be set to Ding Dong and the other push button will be set to
Westminster from the factory.
The following instructions explain how to change the tune on any wireless push
button.
1. Remove the battery from the push button transmitter.
2. Locate the 9 position jumper shown below.
9 position jumper (This pushbutton is set for Ding Dong Chime since 7=off, 8=on,