JVC HR-VCD1 - Manual (Page 30)

30
Troubleshooting
No power is applied to the Player. Ⅵ Is the power cord disconnected?
– Connect it.
Remote control does not function. Ⅵ Are the batteries discharged?
– Replace with new ones.
Disc tray does not come out when OPEN/ Ⅵ Is the power cord disconnected?
CLOSE button is pressed. – Connect it.
Sound is distorted or noise is generated. Ⅵ Is the disc dirty?
Image is garbled. – Wipe off the disc surface with a soft cloth.
Ⅵ Is the correctly connected?
Sound is intermittent.
Ⅵ
Is the disc dirty?
Image is garbled. – Wipe the disc surface with a soft cloth. (
੬
p.4)
Ⅵ Is the disc scratched?
Ⅵ
Is the disc warped?
– Replace the disc with a new one.
No image is displayed on the monitor.
Ⅵ
Is the monitor set to the AV mode?
– Set it to the AV mode.
Noise appears during visual search. Ⅵ This is normal.
Noise appears during normal or slow-motion
Ⅵ
Is the automatic tracking mode engaged?
playback. – Try manual tracking. (
੬
p.19)
No sound from the microphone is heard.
Ⅵ
Is the microphone volume adjusted at the lowest level? (
੬
p.25)
Recording does not function. Ⅵ Is a cassette loaded?
Ⅵ
Is the safety tab on the cassette removed?
– Reseal the slot with adhesive tape.
Tape-to-tape editing or camera recording is not Ⅵ Is the camcorder or another video recorder correctly connected?
possible. Ⅵ Are all necessary power switch turned ON?
Whistling or howling is heard from TV during Ⅵ Move camcorder or camera’s microphone away from TV or reduce
camera recording. TV sound volume.
The Player does not function properly. Ⅵ Microcomputer malfunction. Disconnect the power plug from the
AC outlet and then re-insert it.
The microcomputer will be reset to its initial mode.
Symptoms Check point