JVC TH-D5 Series - Manual (Page 9)

6
If you connect speakers other than those supplied for
the System, use speakers of the same speaker
impedance (SPEAKER IMPEDANCE) indicated on
the rear of the center unit.
DO NOT connect more than one speaker to one
speaker terminal.
TH-D7 only:
– You can install the front speakers on the wall.
When installing them on the wall, do not attach the
stands and base plates.
– When installing the front speakers on the floor,
they are to be assembled before use (see below).
Assembling the front speakers
—TH-D7 only
Before assembling:
Take care not to drop any component part while
assembling; otherwise, it may cause an injury or
damage to the floor.
Prepare a Phillips screwdriver (not supplied).
1
When assembling a speaker with stand:
When assembling a speaker without stand:
When holding a speaker, always grasp the lower
portion.
Assembled speakers:
You can assemble the front speakers either with or without
stands.
Front speaker
(SP-THD7F) (2)
Stand (2)
Base plate (2)
or
Speaker
Screws M4 x 25 mm
(supplied)
Stand
Stand
Speaker
Detach the bottom cover and the screws (M4 x 30 mm)
from the stand, then attach them to the bottom of the
speaker.
Bottom
cover
2
Connect the speaker cord.
(
5)
Stand or speaker
directly
Screws M5 x 115 mm
(supplied)
Base plate
Do not connect the power cord
until all other connections have
been made.
TH-D7D5[U]EN.book Page 6 Wednesday, June 13, 2007 10:19 AM