Jura Capresso E75 - Manual (Page 14)

14
12.10 General cleaning instructions
Ⅲ Never use abrasive articles or corrosive chemicals to clean your
machine.
Ⅲ Wipe down the casing on the inside and out using a soft, damp
cloth.
Ⅲ Clean the pivoting nozzle after each use.
Ⅲ After heating milk, draw off a little hot water in order to clean
the inside of the pivoting nozzle.
Ⅲ You can take off the frothing aid for a thorough cleaning
(Fig. 8).
Ⅲ The water tank should be rinsed out every day and filled with
clean water.
If there is scale visible in the water tank, you can remove it
with a customary descaling agent. Remove the water tank
from the machine for this purpose.
12.11 Regular service
Regular inspections by Jura Service extend the service life and
reliability. Keep the original packaging as transport protection.
12.12 Empty system
This procedure is necessary in order to protect the machine
from damage by frost in transport.
Ⅲ Switch the machine OFF with the ON / OFF switch .
Ⅲ Place a vessel under the pivoting nozzle (14).
Ⅲ Turn the selector switch for coffee or hot water / steam (13) to
position .
Ⅲ Switch your machine back on again with the ON / OFF switch
.
Ⅲ CLOSE TAP
Ⅲ Press the key ̈ for about 5 seconds.
Ⅲ
SYSTEM EMPTYING/PLEASE WAIT. After a
short time, steam comes out.
Ⅲ Draw off steam until the draw-off is automatically stopped.
Ⅲ
CLOSE TAP
13. Cleaning
The machine has an integrated cleaning programme.
If the machine needs cleaning, the report appears on the dis-
play. You can continue to draw off coffee or hot water/steam
and run the cleaning programme later.
Only use Jura cleaning tablets. They are available from your
Jura dealer.
You must not interrupt the cleaning programme once it has
started.
Ⅲ Switch your machine on with the ON / OFF key .
Ⅲ Press the rinsing key for about 3 seconds.
Ⅲ
EMPTY TRAY
Ⅲ Fill the water tank with fresh tap water.
Place a sufficiently large vessel under the height-adjustable
coffee-spout (10), so that the cleaning fluid does not run into
the drip tray.
Ⅲ PRESS RINSE
Ⅲ UNIT CLEANING / PLEASE WAIT
Ⅲ An acoustic signal can be heard.
Ⅲ
EMPTY TRAY
Wait for about 10 seconds before you put the drip tray back
in again.