beautypg.com

Recording & playback, Basic recording, Tape remaining time – JVC GR-DA30U User Manual

Page 14: Quick review

background image

14

EN

Recording & Playback

Basic Recording

Before continuing, perform the procedures listed
below:
• Power

(

੬ 11).

• Loading A Cassette (

੬ 13).

• Remove the lens cap (

੬ 6).

• Select videos at 4:3 size or 16:9 (wide) size

(

੬ 13).

Zoom
Lever

Recording Start/
Stop Button

1

Set the Power Switch to “REC” (

੬ 9).

2

2

Press

START/STOP button to start

recording. “REC” appears on the display
while recording is in progress. To stop
recording, press START/STOP again.

Approximate recording time

Tape

Recording mode

SP

LP

30 min.

30 min.

45 min.

60 min.

60 min.

90 min.

80 min.

80 min.

120 min.

Notes:
• If the Record-Standby mode continues for 5

minutes and no operation is performed, the
camcorder’s power shuts off automatically.

• When a blank portion is left between

recorded scenes on the tape, the time code is
interrupted and errors may occur when editing
the tape. To avoid this, refer to “Recording
From The Middle Of A Tape” (

੬ 15).

• To record in LP (Long Play) mode,

੬ 21.

Tape Remaining Time

Approximate tape remaining time appears on
the display. “– – – min” means the camcorder
is calculating the remaining time. When
the remaining time reaches 2 minutes, the
indication starts blinking.

• The time required to calculate and display

the remaining tape length, and the accuracy
of the calculation, may vary according to
the type of tape used.

Quick Review

Enables you to check the end of the last
recording.Press QUICK REVIEW during the
Recording-Standby mode.

• Tape is rewound for about several seconds

and played back automatically, then pauses
in the Recording-Standby mode for the next
shot.

Notes:
• Distortion may occur at start of playback. This

is normal.

• Slide the Zoom lever repeatedly to change the

sound to on/off.

Power Switch

TAPE!

Appears if a tape is not loaded when the
Recording Start/Stop Button is pressed while
the Power Switch is set to “REC”.

USE CLEANING CASSETTE

Appears if dirt is detected on the heads during
recording. Use an optional cleaning cassette
(

੬ 2).

QUICK REVIEW

GR-DA30US_EN.indb 14

GR-DA30US_EN.indb 14

7/11/2007 6:00:26 PM

7/11/2007 6:00:26 PM