John Deere 210LE - Manual (Page 11)

down
Three-Point Hitch 210LE
Bore Stroke Rod
Lift (1) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3.00 in. (76.2 mm) 8.00 in. (203.0 mm) 2.00 in. (50.8 mm)
Pitch (1) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2.50 in. (63.5 mm) 8.50 in. (215.9 mm) 1.25 in. (31.8 mm)
Tilt (1). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3.00 in. (76.2 mm) 4.75 in. (120.7 mm) 2.00 in. (50.8 mm)
Tires
Rear Front
With mechanical-front-wheel-drive. . . . . . . . . . . . . . . . . . . 16.9-24, 8 PR R4 12-16.5, 8 PR NHS
Category II Three-Point Hitch
Type . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . heavy duty, integral to vehicle mainframe, with individual lever control of the lift, tilt, pitch, and auxiliary functions and with down force and float on the lift circuit
Static lift at lower link, ends horizontal . . . . . . . . . . . . . . . . 6,870 lbf (30.57 kN)
Static lift 24 in. (610 mm) behind lift points . . . . . . . . . . . . 3,790 lbf (16.85 kN)
Controlled hydraulic flow rate, maximum . . . . . . . . . . . . . . 10 gpm (37.9 L/min.)
SAE J/ISO 6016.3.2.1 Operating Weights
Base tractor with full fuel tank and 165-lb. (75 kg)
operator . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9,130 lb. (4141 kg)
Hitch weight / drawbar . . . . . . . . . . . . . . . . . . . . . . . . . . . . 535 lb. (243 kg)
Wheel weights . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1,100 lb. (499 kg)
1.00-cu.-yd. (0.76 m
3 ) bucket. . . . . . . . . . . . . . . . . . . . . . . 740 lb. (336 kg)
1.12-cu.-yd. (0.86 m 3 ) bucket. . . . . . . . . . . . . . . . . . . . . . . 940 lb. (426 kg)
1.25-cu.-yd. (0.96 m 3 ) multipurpose bucket . . . . . . . . . . . . 1,640 lb. (744 kg)
88-in.-wide Cameco-brand box blade . . . . . . . . . . . . . . . . 1,650 lb. (748 kg)
84-in.-wide Cameco-brand box blade . . . . . . . . . . . . . . . . 1,620 lb. (735 kg)
Maximum allowable operating weight . . . . . . . . . . . . . . . . 16,000 lb. (7257 kg)
Loader Buckets
Width Heaped Capacity Weight
Heavy-duty long lip. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 86 in. (2180 mm) 1.00 cu. yd. (0.76 m 3 ) 710 lb. (322 kg)
86 in. (2180 mm) 1.12 cu. yd. (0.86 m 3 ) 940 lb. (426 kg)
Multipurpose . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 86 in. (2180 mm) 1.12 cu. yd. (0.86 m 3 ) 1,450 lb. (658 kg)
Loader Performance
with 1.00-cu. yd. (0.76 m 3 ) with 1.12-cu. yd. (0.86 m 3 ) with 1.25-cu. yd. (0.96 m 3 )
Heavy-Duty Long Lip Bucket Heavy-Duty Long Lip Bucket Multipurpose Bucket
Operator control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . single lever single lever single lever
Breakout force . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7,900 lbf (35.14 kN) 7,750 lbf (34.47 kN) 6,900 lbf (30.69 kN)
Lifting capacity, full height . . . . . . . . . . . . . . . . . . . . . . . . . 5,280 lb. (2395 kg) 5,100 lb. (2313 kg) 4,600 lb. (2086 kg)
Height to bucket hinge pin, maximum . . . . . . . . . . . . . . . . 11 ft. 4.7 in. (3.47 m) 11 ft. 4.7 in. (3.47 m) 11 ft. 4.7 in. (3.47 m)
Dump clearance, bucket at 45 degrees . . . . . . . . . . . . . . . 8 ft. 4.6 in. (2.56 m) 8 ft. 4.4 in. (2.55 m) 8 ft. 0.5 in. (2.45 m)
Reach at full height, bucket at 41.6 degrees . . . . . . . . . . . 34.4 in. (875 mm) 33.8 in. (858 mm) 35.4 in. (899 mm)
Rollback angle at ground level . . . . . . . . . . . . . . . . . . . . . . 44 degrees 44 degrees 44 degrees
Digging depth below ground, bucket level . . . . . . . . . . . . . 9.6 in. (245 mm) 10.2 in. (259 mm) 11.8 in. (300 mm)
Raising time to full height. . . . . . . . . . . . . . . . . . . . . . . . . . 5.2 sec. 5.2 sec. 5.2 sec.
Bucket dump time . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1.5 sec. 1.5 sec. 1.5 sec.
Bucket lowering time (power down) . . . . . . . . . . . . . . . . . . 2.4 sec. 2.4 sec. 2.4 sec.
Tractor Loader Dimensions
A At 45-degree dump angle . . . . . . . . . . . . . . . . . . . . 10 ft. 10.9 in. (3.33 m)
At full height . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 ft. 4.7 in. (3.47 m)
B At 45-degree dump angle . . . . . . . . . . . . . . . . . . . . 8 ft. 4.6 in. (2.56 m)
At full height . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 ft. 9.7 in. (2.69 m)
C Bucket pin 11 in. (280 mm) off ground . . . . . . . . . . 44 degrees
D At full height . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 41.6 degrees
E At 45-degree dump angle . . . . . . . . . . . . . . . . . . . . 37.0 in. (940 mm)
At full height . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 34.4 in. (874 mm)
F Lower link horizontal. . . . . . . . . . . . . . . . . . . . . . . . 45.0 in. (1143 mm)
G Bucket level . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9.6 in. (244 mm)
H Bucket level on ground . . . . . . . . . . . . . . . . . . . . . . 78.1 in. (1984 mm)
Bucket rolled back, pin 11 in. (280 mm) off ground . . . 76.6 in. (1946 mm)
I Wheelbase . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 83.3 in. (2116 mm)
J Transport height . . . . . . . . . . . . . . . . . . . . . . . . . . . 97.6 in. (2479 mm)
K Bucket level on ground . . . . . . . . . . . . . . . . . . . . . . 17 ft. 2 in. (5.2 m)
L Lower link pin center . . . . . . . . . . . . . . . . . . . . . . . 1.6 in. (40 mm)
M Static loaded radius . . . . . . . . . . . . . . . . . . . . . . . . 23.0 in. (584 mm)
N Ground clearance
Under MFWD axle . . . . . . . . . . . . . . . . . . . . . . . . . . 11.3 in. (287 mm)
Under transmission . . . . . . . . . . . . . . . . . . . . . . . . . 12.3 in. (312 mm)
Width over rear tires . . . . . . . . . . . . . . . . . . . . . . . . 84.0 in. (2134 mm)
Three-Point Hitch Dimensions
a Height of hole for top link . . . . . . . . . . . . . . . . . . . . 30.8 in. (783 mm)
b Height of rear axle center . . . . . . . . . . . . . . . . . . . . 23.0 in. (584 mm)
c Top link hole distance from rear axle center . . . . . . 17.7 in. (450 mm)
d Height of lower link point . . . . . . . . . . . . . . . . . . . . 18.3 in. (465 mm)
e Lower link point distance from rear axle center . . . 14.0 in. (356 mm)
f Pitch cylinder (top link)
Retracted . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22.5 in. (572 mm) min.
Extended. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 31.0 in. (788 mm) max.
g Lower link length . . . . . . . . . . . . . . . . . . . . . . . . . . 29.5 in. (749 mm)
h Maximum height of lower link. . . . . . . . . . . . . . . . . 28.1 in. (714 mm)
i Minimum height of lower link . . . . . . . . . . . . . . . . . 7.7 in. (196 mm)
j Height of drawbar . . . . . . . . . . . . . . . . . . . . . . . . . . 12.8 in. (325 mm)
k Hitch pin from rear axle center . . . . . . . . . . . . . . . . 33.2 in. (843 mm)
B
G
C
M
D
E
K
I
N
F H
L
A J
b
a
j
d
e
k
g
i
h
f
c
DKA210LE Page 11
Vertis QCA
1300 19th Street, Suite 200
East Moline, IL 61244 Cyan Magenta Yellow Black
DKA210LE_SPECS 9/19/05 11:16 AM Page 11