JVC DT-V17G1 User Manual

Page 9

ENGLISH

To detach the cover

AC IN
terminal

Case

Cover

CAUTION

• Use only the provided screws.
• Make sure the plug will not be pulled out after the cover is attached to the case.

Attaching the power cord holder

The provided power cord holder prevents accidental disconnection of the AC power cord from the AC IN
terminal.
• The power cord holder consists of two parts, a case and a cover.

p DC IN 12V terminal

DC 12 V (maximum
DC 17 V) power input
connector.

• While using both the AC and DC 12 V power

supply, AC power supply is preferentially used. If
the AC power supply is cut off (for example, when
turning off the POWER switch), the power supply
automatically switches to the DC 12 V power
supply.

q AC IN terminal

AC power input connector.
Connect the provided AC power cord to an AC
outlet.
• Attach the provided power cord holder to prevent

accidental disconnection of the AC power cord.

(

☞ “Attaching the power cord holder” on page 9)

w POWER switch

Turns AC power on or off.
• You need to press

button (

☞ u on page 6)

to use the monitor after turning on the POWER
switch.

e Screw holes for external battery attachment

Attach external battery for DC 12 V power supply
by using 2 screw holes. Choose the appropriate
screw holes from 1, 2 or 3 according to the type of
external battery.
• Use the Anton Bauer Dionic 90 (mount: QR DXC-

M3A) external battery.

CAUTION

• Do not use the external battery for DC 24 V

power supply.

• Use only the battery specified above. If a heavy

battery is used, it may fall off depending on the
way the monitor is used.

• When an external battery is attached, attach the

ferrite core (provided) to the power cord from the
mount as illustrated below.

r Security slot

Attach a security wire to this slot.

Note for connections

• Before making any connections, turn off all the

equipment.

• Use a cord whose plugs correctly match the

terminals on this monitor and the equipment.

• Plugs should be firmly inserted; poor connections

could cause noise.

• When unplugging a cord, be sure to grasp its plug

and pull it out.

• DO NOT connect the power cord until all connections

are complete.

• Refer also to the user manual of each piece of

equipment.

Ex.: When the Anton Bauer mount (QR DXC-M3A)

is used

Ferrite core

When using DC 12 V power (maximum DC 17 V),
check the DC IN 12V terminal pin signal, and use
the correct polarity. If the polarity is reversed, this
could cause a fire or personal injury.

DT-V17G1_EN.indd 9

09.12.3 7:55:15 PM