JVC RX-8010VBK - Manual (Page 37)

34
English
4. Adjust the overall levels of the effect.
1) Press EFFECT repeatedly until
“EFFECT” appears on the display.
The display shows the current setting.
2) Press CONTROL UP 5/DOWN ∞
to select the effect level you want.
• Each time you press the button, the
display changes to show the following:
As the number increases, the selected 3D effect mode
becomes stronger. (Normally set it to “EFFECT 3.”)
From the remote control:
1. Press DSP MODE repeatedly until
“3D ACTION” or “3D DIGITAL”
appears on the display.
The DSP MODE lamp on the front panel button lights up, and
the 3D-PHONIC and DSP indicators also light up on the display.
2. Press SOUND.
The 10 keys are activated for sound
adjustments.
3. Press CENTER to select the center
speaker.
• “CTR” appears on the remote control display
window.
4. Press LEVEL +/– to adjust the
center speaker output levels (from
–10 dB to +10 dB).
5. Press SOUND.
2
EFFECT
MENU
EFFECT 1 EFFECT 2 EFFECT 3
EFFECT 4 EFFECT 5
5
ENTER
CTR TONE 6. Press CTR TONE to select the
center tone level you want.
• Each time you press the button, the display
changes to show the following:
To make the dialogue softer, select “CTR TONE 1” or “CTR
TONE 2.”
To make the dialogue clearer, select “CTR TONE 4” or “CTR
TONE 5.”
When “CTR TONE 3” is selected, no adjustment is applied.
7. Press EFFECT to adjust the
overall level of the effect.
• Each time you press the button, the effect
level changes as follows:
As the number increases, 3D effect mode becomes stronger.
(Normally set it to “EFFECT 3.”)
CTR TONE 1 CTR TONE 2 CTR TONE 3
CTR TONE 4 CTR TONE 5
(Softer) (Soft) (Flat)
(Sharper) (Sharp)
EFFECT SETT
CONTROL
DOWN UP
EFFECT 1 EFFECT 2 EFFECT 3
EFFECT 4 EFFECT 5
MODE
DSP
SOUND
9
∗
CENTER
SOUND
+
−
CH/
∗
LEVEL
∗
BAL L
∗
BAL R
EN24_35.RX-8010V[C]_f 01.4.3, 9:46 AM 34