English – JVC RX-8010VBK User Manual

Page 36

English

4. Press LEVEL +/– to adjust the

speaker output levels (–10 dB to
+10 dB).

5. Press SOUND.

• To adjust other speaker output levels, repeat

steps 3 and 4.

6. Press CTR TONE to select the

center tone level you want — for
5 CH Stereo mode only.

The center tone adjustment affects the mid-
frequency range, which the human voice is
mostly made up of.
• Each time you press the button, the display changes to show

the following:

To make the dialogue softer, select “CTR TONE 1” or “CTR
TONE 2.”
To make the dialogue clearer, select “CTR TONE 4” or “CTR
TONE 5.”
When “CTR TONE 3” is selected, no adjustment is applied.

+
−

CH/

∗

LEVEL

∗

BAL L

∗

BAL R

ENTER

CTR TONE

SOUND

CTR TONE 1

CTR TONE 2

CTR TONE 3

CTR TONE 4

CTR TONE 5

(Softer)

(Soft)

(Flat)

(Sharper)

(Sharp)

Adjusting the 3D-PHONIC Modes

Before you start, remember...
• Make sure that you have set the speaker information correctly

(see page 17).

• There is a time limit in doing the following steps. If the setting is

canceled before you finish, start from step 2 again.

• You cannot adjust the center speaker output level when you have

set “CTR SPK” to “NONE.” See page 17.

• To adjust the front speaker output balance and subwoofer output

level, see pages 16 and 17.

On the front panel:

1. Press DSP MODE repeatedly until

“3D ACTION” or “3D DIGITAL”
appears on the display.

The DSP MODE lamp on the front panel
button lights up, and the 3D-PHONIC and DSP indicators also
light up on the display.

2. Adjust the center speaker output level.

1) Press LEVEL ADJUST repeatedly

until “CENTER” appears on the
display.

2) Press CONTROL UP

5/DOWN ∞ to

adjust the center speaker output level
(from –10 dB to +10 dB).

3. Adjust the center tone.

1) Press EFFECT repeatedly until “CTR

TONE” appears on the display.
The display shows the current setting.

2) Press CONTROL UP

5/DOWN ∞

to select the center tone level you
want.
The center tone adjustment affects the
mid-frequency range, which the human
voice is mostly made up of.
• Each time you press the button, the

display changes to show the following:

To make the dialogue softer, select “CTR TONE 1” or
“CTR TONE 2.”
To make the dialogue clearer, select “CTR TONE 4” or
“CTR TONE 5.”
When “CTR TONE 3” is selected, no adjustment is applied.

DSP MODE

LEVEL

ADJUST

CONTROL

DOWN