JVC GR-DVL155 - Manual (Page 6)

6
EN
Automatic Demonstration takes place when “DEMO
MODE” is set to “ON” (factory-preset).
Ⅲ
Automatic Demonstration starts when there is no operation for
about 3 minutes after the Power Switch is set to “
AUTO ” or
“ MANUAL ” and no cassette is in the camcorder.
Ⅲ
Performing any operation during the demonstration stops the
demonstration temporarily. If no operation is performed for more
than 3 minutes after that, the demonstration will resume.
Ⅲ
“DEMO MODE” remains “ON” even if the camcorder power is
turned off.
Ⅲ
To cancel Automatic Demonstration:
1. Set the Power Switch to “
MANUAL ” while pressing down the
Lock Button located on the switch and press the MENU/
BRIGHT wheel in. The Menu Screen appears.
2. Rotate the MENU/BRIGHT wheel to select “ SYSTEM”
and press it. The SYSTEM Menu appears.
3. Rotate the MENU/BRIGHT wheel to select “DEMO MODE”
and press it. The Sub Menu appears.
4. Rotate the MENU/BRIGHT wheel to select “OFF” and press it.
5. Rotate the MENU/BRIGHT wheel to select “
RETURN”,
and press it twice. The normal screen appears.
NOTE:
If you do not detach the Lens Cap, you cannot see the actual changes of the
Automatic Demonstration activated on the LCD monitor or viewfinder.
AUTOMATIC DEMONSTRATION
MODE DEMO –
ON
OF F
MENU/BRIGHT Wheel
Sub Menu
Lock Button
Power Switch
How To Attach The Core Filter
Attach the Core Filter(s) (if provided with your model
੬
pg. 5) to an optional cable(s). The Core Filter
reduces interference.
Release the
stoppers on both
ends of the Core
Filter. Run the cable through the Core Filter, leaving approx.
3 cm of cable between the cable plug and the Core Filter.
Wind the cable once around the outside of the Core Filter
as shown in the illustration.
• Wind the cable so that it is not slack.
NOTE:
Take care not to damage the cable.
Close the Core Filter until it
clicks shut.
3 cm
Stopper
Ⅲ When connecting cables, attach the end with the Core Filter to the camcorder.
1
Wind once
2 3