JVC GR-DVL155 User Manual
Page 35
EN
35
SYSTEM
DISPLA
Y
DEMO
MODE
CAM
RESET
ON
SCREEN
DATE/
TIME
TIME
CODE
CLOCK ADJ.
OFF
ON
CANCEL
EXECUTE
LCD
LCD/TV
OFF
AUTO
ON
OFF
ON
: Factory-preset
NOTES:
●
“
SYSTEM” and “
DISPLAY” functions which are set when the Power Switch is set to “
MANUAL
” are also applied
when the Power Switch is set to “PLAY” (
੬
pg. 36). “CLOCK ADJ.” only appears when the Power Switch is set to
“
MANUAL
”.
●
Settings made in the “
DISPLAY” Menu remain effective even when the Power Switch is set to “
AUTO
”. However,
the menu settings can be changed only when the Power Switch is set to “
MANUAL
”.
Automatic demonstration will not take place.
Demonstrates certain functions such as Programme AE with special effects,
etc., and can be used to confirm how these functions operate.
Demonstration starts in the following cases:
• When the Menu Screen is closed after “DEMO MODE” is turned “ON”.
• With “DEMO MODE” set to “ON”, if there is no operation for about 3 minutes
after the Power Switch is set to “
AUTO
” or “
MANUAL
” .
Performing any operation during the demonstration stops the demonstration
temporarily. If no operation is performed for more than 3 minutes after that, the
demonstration will resume.
NOTES:
●
If a tape is in the camcorder, the demonstration cannot be turned on.
●
“DEMO MODE” remains “ON” even if the camcorder power is turned off.
●
If “DEMO MODE” remains “ON”, some functions will not be available. After
viewing demo, set to “OFF”.
Does not reset all settings to the factory-preset.
Resets all settings to the factory-preset.
Keeps the camcorder’s display (except the date, time and time code) from
appearing on the connected TV screen.
Makes the camcorder’s display appear on screen when the camcorder is
connected to a TV.
The date/time does not appear.
Displays the date/time for approx. 5 seconds in the following cases:
• When the Power Switch is set from “OFF” to “
AUTO
” or “
MANUAL
”.
• When tape playback starts. The camcorder displays the date/time when
scenes are recorded.
• When the date is changed during tape playback.
The date/time is always displayed.
Time code is not displayed.
Time code is displayed on the camcorder and on the connected TV. Frame
numbers are not displayed during recording.
Allows you to set the current date and time (
੬
pg. 11).