JVC GR-DVL155 - Manual (Page 19)

EN
19
Rewind Button ( 2 )
Fast-Forward Button ( 3 )
Play/Pause Button ( 4 / 6 )
Stop Button ( 5 )
Power Zoom Lever
(VOL.)
Speaker
PLAYBACK
Normal Playback
1
Load a tape (
੬
pg. 12).
2
Set the Power Switch to “PLAY” while pressing down
the Lock Button located on the switch. To start playback,
press
4 / 6 .
• To stop playback, press 5 .
• Press 2 to rewind, or 3 to fast-forward the tape
during Stop mode.
To Control The Speaker Volume . . .
..... slide the Power Zoom Lever (VOL.) towards “+”
to turn up the volume, or towards “–” to turn down
the volume.
NOTES:
●
If Stop mode continues for 5 minutes when power is supplied from a battery, the camcorder shuts off automatically. To
turn on again, set the Power Switch to “OFF”, then to “PLAY”.
● The playback picture can be viewed in the LCD monitor, viewfinder or on a connected TV (
੬
pg. 20).
●
You can also view the playback picture on the LCD monitor with it flipped over and pushed against the camera body.
●
LCD monitor/viewfinder indications:
• When power is supplied from a battery: the “
” battery pack remaining power indicator is displayed.
When power is supplied from an AC outlet: “ ” does not appear.
• During Stop mode, none of the indications are displayed.
●
When a cable is connected to the AV connector, the sound is not heard from the speaker.
Still Playback: Pauses during playback.
1) Press 4 / 6 during playback.
2) To resume normal playback, press 4 / 6 again.
●
If still playback continues for more than about 3 minutes, the camcorder’s Stop mode is automatically engaged.
After 5 minutes in the Stop mode, the camcorder’s power is automatically turned off.
●
When 4 / 6 is pressed, the image may not pause immediately while the camcorder stabiliseds the still image.
Shuttle Search: Allows high-speed search in either direction.
1) Press 3 for forward or 2 for reverse search during playback.
2) To resume normal playback, press 4 / 6 .
●
During playback, press and hold 2 or 3 . The search continues as long as you hold the button. Once you
release it, normal playback resumes.
●
A slight mosaic effect appears on screen during Shuttle Search. This is not a malfunction.
Frame-By-Frame Playback: Allows frame-by-frame search.
1) Engage Still Playback.
2) Rotate the MENU/BRIGHT wheel towards “+” for forward Frame-By-Frame Playback, or towards “–” for
reverse Frame-By-Frame Playback during Still Playback.
●
To resume normal playback, press 4 / 6 .
ATTENTION
During Shuttle Search, parts of the picture may not be clearly visible, particularly on
the left side of the screen.