JVC GR-DVL155 - Manual (Page 48)

48
EN
Audio Dubbing
The audio track can be customized only when
recorded in the 12-bit mode (
੬
pg. 33).
NOTES:
●
Audio Dubbing is not possible on a tape recorded in 16-
bit audio, on a tape recorded in the LP mode or on a
blank portion of a tape.
●
To perform Audio Dubbing while watching on the
television, make connections (
੬
pg. 20).
1
Play back the tape to locate the point where
editing will start, then press PAUSE ( 6 ).
2
While holding A.DUB ( e ) on the remote control,
press PAUSE ( 6 ). “ 6e ” appears.
3
Press PLAY ( 4 ) , then begin “narrating”.
Speak into the microphone.
• To pause dubbing, press PAUSE (
6 ).
4
To end Audio Dubbing, press PAUSE ( 6 ), then
STOP ( 5 ).
To hear the dubbed sound during playback . . .
..... set “12BIT MODE” to “SOUND 2” or “MIX” in the
Menu Screen (
੬
pg. 36, 37).
NOTES:
●
Sound is not heard from the speaker during Audio
Dubbing.
● When editing onto a tape that was recorded at 12-bit,
the old and new soundtracks are recorded separately.
●
If you dub onto a blank space on the tape, the sound
may be disrupted. Make sure you only edit recorded
areas.
●
If feedback or howling occurs during TV playback,
move the camcorder’s microphone away from the TV,
or turn down the TV’s volume.
●
If you change from 12-bit to 16-bit in mid-recording and
then use the tape for Audio Dubbing, it is not effective
from the point where 16-bit recording began.
●
During Audio Dubbing, when the tape moves to scenes
recorded in the LP mode, scenes recorded in 16-bit
audio or a blank portion, Audio Dubbing stops
(
੬
pg. 66).
e 6
A.DUB
PAUSE
PLAY
STOP
Speaker
Stereo
microphone
Audio Dub
Standby mode
Power Switch
Remote sensor
Display
RM-V700U
(optional)
USING THE OPTIONAL REMOTE CONTROL UNIT
(cont.)