JVC RX-60VGD - Manual (Page 43)

40
English
IMPORTANT:
To operate JVC video components using this remote control:
•
Aim the remote control directly at the remote sensor on the video components,
not on the receiver.
• When the TV is connected to with the AV COMPU LINK cable (see page 37), aim
the remote control directly at the remote sensor on the receiver to operate the TV.
7 7 7 7 7 After pressing VCR, you can perform the
following operations on the VCR:
3
Starts playback.
1 Rewinds a video tape.
¡ Fast winds a video tape.
7
Stops operation.
8 Pauses. To resume playing, press 3.
CH +/– Changes the TV channel on the VCR.
You can always do the following on the VCR:
VCR
Turn on and off the VCR
(in the POWER section)
7 7 7 7 7 After pressing TV SOUND, you can perform the
following operations on the TV:
CH +/–
Changes the channels
1 – 9, 0, +10 Selects the channels.
RETURN Alternates between the previously
selected channel and the current
channel.
You can always do the following on the TV:
TV VOLUME +/–
Adjust the volume.
TV/VIDEO Sets the input mode (either TV or
VIDEO)
TV Turns on or off the TV
(in the POWER section)
Note:
If you choose a source on the front
panel, the remote control will not
operate that source.
SOUND CONTROL
ONE TOUCH
OPERATION TV/VIDEO
TV
VCD CONTROL VCD-DISC CD-DISC
VCR AUDIO
CENTER REAR
(L) CH TV
VOLUME
RETURN/ENTER
3 2 1
6 5 4
9 8
0
7/P
+10 10
PHONO
CD
VCR
MUTING
VOLUME
DVD MULTI
TAPE
DVD
POWER
TUNER/ BAND
TV
SOUND
RM-SR60U
REMOTE CONTROL
DAP MODE 3D-PHONIC SURROUND
EFFECT DELAY TEST
SEA MODE SEA PRESET MENU
– REAR•R +
VCD
Note:
Some JVC VCRs can accept two
types of the control signals —
code “A” and “B.” Before using this
remote control, make sure that the
remote control code of the VCR
is set to code “A.”
EN20-46.RX-60VGD[UF]/F 98.8.27, 5:33 PM 40