JVC RX-60VGD - Manual (Page 40)

37
English
AV COMPU LINK Remote Control System
The AV COMPU LINK remote control system allows you to operate JVC video components (TV, VCR, and
DVD player) through the receiver.
Notes:
• Without connecting the video
components with RCA pin plugs
as described on page 7, the AV
COMPU LINK remote control
system cannot operate the
components.
• You can use either AV COMPU
LINK jacks to connect the video
components.
• Refer also to the instructions
supplied with your video
components.
To use this remote control system, you need to connect the video components you want
to operate, following the procedures below.
1. Connect your VCR, DVD player and TV as follows, using the cable with the
monaural mini-plug (only one cable is supplied with this receiver).
2. Connect the VCR, DVD player, and TV using the cables with RCA pin plug, see
pages 7 and 8.
If you connect the VCR or DVD player to the TV directly using an S-video
cable, leave the corresponding video input on this receiver unplugged — VCR IN
(PLAY) for the VCR or DVD for the DVD player.
3. When turning on the TV for the first time after the AV COMPU LINK
connection, turn the TV volume to the minimum using the TV volume control
on the TV.
AV
COMPU LINK
VHS
DVD
TV
DVD player VCR
EN20-46.RX-60VGD[UF]/F 98.8.27, 5:33 PM 37