JVC RX-7012RSL - Manual (Page 21)

18
Receiving Radio Broadcasts
You can browse through all the stations or use the preset function to go immediately to a particular station.
Using Preset Tuning
Once a station is assigned to a channel number, the station can be
quickly tuned. You can preset up to 30 FM and 15 AM (MW/LW)
stations.
To store the preset stations
Before you start, remember...
• There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
On the front panel ONLY:
1. Tune in the station you want to preset (see
“Tuning in Stations Manually”).
• If you want to store the FM reception mode for this station,
select the FM reception mode you want. See “Selecting the
FM Reception Mode” on page 19.
2. Press MEMORY.
“CH-” appears and the channel number position starts flashing
on the display for about 5 seconds.
3. Press FM/AM PRESET
5/ ∞ to
select a channel number while the
channel number position is flashing.
Note:
You can use the 10 keys on the remote control to select the preset
number. When using the 10 keys, be sure that they are activated
for the tuner, not for the CD and others. (See page 32.)
4. Press MEMORY again while the
selected channel number is flashing on
the display.
The selected channel number stops flashing.
The station is assigned to the selected channel number.
5. Repeat steps 1 to 4 until you store all the
stations you want.
To erase a stored preset station
Storing a new station on a used number erases the previously stored
one.
FM/AM
FM/AM TUNING
L
SPK
TUNED VOLUME ANALOG
1
R
FM/AM
TUNING
+
−
Tuning in Stations Manually
On the front panel:
1. Press FM/AM to select the band
(FM or AM — MW/LW).
The last received station of the selected band
is tuned in.
• Each time you press the button, the band alternates between
FM and AM (MW/LW).
2. Press FM/AM TUNING
5/ ∞until
you find the frequency you want.
• Pressing FM/AM TUNING 5 increases
the frequency.
• Pressing FM/AM TUNING ∞ decreases
the frequency.
From the remote control:
1. Press FM/AM to select the band.
• Each time you press the button, the band
alternates between FM and AM (MW/LW).
2. Press TUNING +/– until you find
the frequency you want.
• Pressing TUNING + increases the
frequency.
• Pressing TUNING – decreases the
frequency.
Notes:
• When a station of sufficient signal strength is tuned in, the TUNED
indicator lights up on the display.
• When an FM stereo program is received, the STEREO indicator
also lights up.
L
SPK
TUNED VOLUME ANALOG
1
R
MEMORY
L
CH-
SPK
TUNED VOLUME ANALOG
1
R
FM/AM PRESET
L
CH-
SPK
TUNED VOLUME ANALOG
1
R
MEMORY
L
CH-
SPK
TUNED VOLUME ANALOG
1
R
EN10_22.RX-7010&7012R[B]_f 01.1.9, 5:23 PM 18