Names and functions of various parts, Front panel, Operate] operate button/led – JVC BR-DV3000 User Manual
Page 10: Cassette slot, A. dub] audio dubbing button/led, Input sel.] input video signal se- lection switch
E-10
Mini
PROFESSIONAL
SET
MENIU
EJECT
REC
PLAY
PAUSE
REW
STOP
FF
DVCAM NTSC
PAL REC INH.
CH-1/3
CH-2/4
BR-DV3000
A.DUB
OPERATE
INPUT SEL.
REMOTE SEL.
MIC
SERIAL
WIRELESS
9PIN
LINE
DV
Y/C
2
4 3
1
1
[OPERATE] Operate button/LED
● Press this button to turn on the power and op-
erate the unit. (Operate ON)
Press this button again to turn off the power.
(Operate OFF)
● The OPERATE LED lights up as follows.
Operate ON
: the LED lights up green
Operate OFF : the LED lights up red
VTR error
: the LED blinks in red
Memo
● When the DC IN MODE item of the SYS-
TEM menu is set to “OPE ON” and power is
supplied to the
1
DC IN terminal located at
the rear panel, the unit goes into the OPER-
ATE ON state even if this button is not
pressed.
● Even when the power has been turned off
with this button, a small amount of electric-
ity will still be channeled into the unit.
Therefore, if the unit is not going to be used
for a long period of time, please remove the
AC adapter to reduce energy consumption.
2
Cassette slot
● Load a cassette into or unload it from the slot.
Please insert a standard DV or a mini DV cas-
sette. (
☞ Page 30)
● When the unit is in the OPERATE OFF state
and if a cassette is loaded, it goes into the
ON state.
3
[A. DUB] Audio dubbing button/LED
● Press this button for audio dubbing (after-re-
cording).
For audio dubbing, set the AUDIO MODE item
of the AUDIO/VIDEO menu to “32K”.
Sound produced by the
6
MIC terminal or
the
9
AUDIO IN terminal at the rear panel
(
☞ Page 15) is recorded on CH3 and CH4
channels.
● During audio dubbing, the A. DUB LED lights
up red.
● If the INPUT SEL. switch is set at “DV”, audio
dubbing is not possible.
(
☞ Page 39, “Audio dubbing”)
4
[INPUT SEL.] Input video signal se-
lection switch
● Select the video signal input with this switch.
Y/C
: YC separate video signals from the Y/
C IN terminal
LINE : composite video signals from the LINE
IN terminal
DV
: DV signals from the DV IN/OUT termi-
nal (IEEE1394)
Note
During recording, manipulating this switch will
not bring about any effect.
NAMES AND FUNCTIONS
OF VARIOUS PARTS
–
Front panel
–