JVC DT-V24L3D - Manual (Page 3)

Dear Customer,
This apparatus is in conformance with the valid
European directives and standards regarding
electromagnetic compatibility and electrical safety.
European representative of Victor Company of Japan,
Limited is:
JVC Technical Services Europe GmbH
Postfach 10 05 04
61145 Friedberg
Germany
Information for Users on Disposal of Old
Equipment
[European Union]
This symbol indicates that the
electrical and electronic equipment
should not be disposed as general
household waste at its end-of-
life. Instead, the product should
be handed over to the applicable
collection point for the recycling of
electrical and electronic equipment
for proper treatment, recovery and
recycling in accordance with your
national legislation.
By disposing of this product
correctly, you will help to conserve
natural resources and will help
prevent potential negative effects
on the environment and human
health which could otherwise
be caused by inappropriate waste handling of this
product. For more information about collection point
and recycling of this product, please contact your
local municipal office, your household waste disposal
service or the shop where you purchased the product.
Penalties may be applicable for incorrect disposal of
this waste, in accordance with national legislation.
(Business users)
If you wish to dispose of this product, please visit our
web page www.jvc-europe.com to obtain information
about the take-back of the product.
[Other Countries outside the European Union]
If you wish to dispose of this product, please do so in
accordance with applicable national legislation or other
rules in your country for the treatment of old electrical
and electronic equipment.
Attention:
This symbol is
only valid in the
European Union.
WARNING: TO PREVENT FIRE OR SHOCK HAZARDS, DO NOT EXPOSE THIS
APPARATUS TO RAIN OR MOISTURE.
WARNING: THIS APPARATUS MUST BE CONNECTED TO A MAINS SOCKET OUTLET
WITH A PROTECTIVE EARTHING CONNECTION.
CAUTION: DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY REPLACED.
REPLACE ONLY WITH THE SAME OR EQUIVALENT TYPE.
IMPORTANT SAFETY INSTRUCTIONS
1) Read these instructions.
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this apparatus near water.
6) Clean only with dry cloth.
7) Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
8) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including
amplifiers) that produce heat.
9) Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one
wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the
third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for
replacement of the obsolete outlet.
10) Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point
where they exit from the apparatus.
11) Only use attachments/accessories specified by the manufacturer.
12) Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or
sold with the apparatus. When a cart is used, use caution when moving the cart/
apparatus combination to avoid injury from tip-over.
13) Unplug this apparatus during lightning storms or when unused for long periods of time.
14) Refer all servicing to qualified service personnel. Servicing is required when the
apparatus has been damaged in any way, such as power-supply cord or plug is
damaged, liquid has been spilled or objects have fallen into the apparatus, the
apparatus has been exposed to rain or moisture, does not operate normally, or has
been dropped.
15) Apparatus shall not be exposed to dripping or splashing and no objects filled with liquids, such as vases, shall be
placed on the apparatus.
16) Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
17) When discarding batteries, environmental problems must be considered and the local rules or laws governing the
disposal of these batteries must be followed strictly. 3
European Union only
FCC NOTICE
CAUTION: Changes or modifications not approved by JVC could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the user will be required to correct the interference at
his own expense.
IMPORTANT RECYCLING INFORMATION
This product has a fluorescent lamp that contains mercury. Disposal of these materials
may be regulated in your community due to environmental considerations. For disposal
or recycling information, please contact your local authorities or for USA, the Electronic
Industries Alliance: http://www.eiae.org
U.S.A. only
EMC Supplement
This equipment is in conformity with the provisions
and protection requirements of the corresponding
European Directives. This equipment is designed for
professional video appliances and can be used in the
following environments:
• Controlled EMC environment (for example purpose
built broadcasting or recording studio), and rural
outdoors environment (far away from railways,
transmitters, overhead power lines, etc.)
In order to keep the best performance and ensure
electromagnetic compatibility, we recommend to use
cables not exceeding the following length:
Cable Length
Power cord 2.0 m
(attached cable (H05VV-F 3 x 0.75 mm 2 ))
Video signal cable 2.0 m
(coaxial cable)
Audio signal cable (shielded cable) 1.5 m
DVI cable (shielded cable) 1.5 m
RS-232C cable (shielded cable) 2.0 m
(A straight cable with a D-sub 9-pin connector)
RS-485 cable (twist pair cable) 2.0 m
(A straight LAN cable)
REMOTE cable (twist pair cable) 2.0 m
(A straight LAN cable)
The inrush current of this apparatus is 6 ampere.
CAUTION
In case where the strong electromagnetic waves or
magnetism are near the audio cable or the signal
cable, the sound or the picture will contain noise. In
such cases, please keep the cable away from the
sources of the disturbance.
DT-V24_20L3D_EN.indd 3 DT-V24_20L3D_EN.indd 3 08.5.27 5:14:48 PM 08.5.27 5:14:48 PM