JVC DLA-RS0 - Manual (Page 50)

5 Troubleshooting
50
Replacing the Lamp (Continued)
BACK
TEST HIDE
BRIGHT CONT SHARP
COLOR TINT N.R
GAMMA C.TEMP
INFO LENS.AP ASPECT
LENS INPUT
STANDBY ON
MENU
CINEMA1 CINEMA2
NATURAL STAGE DYNAMIC
USER1 USER2 USER3
LIGHT
Resetting Lamp Time
W ARNING
LAMP
ST ANDBY/ON
● Reset the lamp time only when you
have replaced the lamp.
● Never reset the service time w hen
the lamp is still in use. Otherwise,
the approximate standard for gauging
replacement time may be inaccurate
and lamp blowout may occur.
Press for 2 seconds or more
Light on (Red)
HIDE BACK
CAUTION
After replacing the lamp, reset the lamp time.
1 Insert the power plug to the power
outlet
2 Must operate with the remote control
in the standby mode (the projector is
powered, but is not turned on).
● Press in the order as shown.
● Press each button within -second intervals and press the last
button for 2 seconds or more.
● [STANDBY/ON] indicator and [LAMP] indicator blink alternately for
3 seconds. After that, the unit switches to standby mode.