Jura Capresso IMPRESSA C9 - Manual (Page 23)

If you do not want to change another button, turn the dial
until the display shows
EXIT and push the Rotary Dial: READY .
Example 2:
Re-program the Cappuccino button to: 3.5 oz. of coffee, strong,
milk for 20 seconds, temperature stays at
HIGH .
READY .
1. Push the Rotary Dial until the display shows RINSE .
2. Turn the Rotary Dial to BUTTONS and push the Rotary Dial.
The display shows SELECT BUTTON .
3. Push the CAPPUCCINO button. The display shows MILK .
4. Push the Rotary Dial, 14 SEC , and turn the dial until the
display shows 20 SEC .
5. Push the Rotary Dial to confirm: OK then MILK .
6. Turn the Rotary Dial until display shows WATER (here it
stands for coffee volume) and push the Dial, 2.0 OZ .
7. Turn the Rotary Dial until the display shows 3.5 OZ and push
to confirm, OK then WATER .
8. Turn the Rotary Dial until the display shows STRENGTH and
push the Dial, NORMAL .
9. Turn the Dial until the display shows STRONG and push the
Dial, OK , then STRENGTH .
10. Turn the Rotary Dial until the display shows EXIT and push
the dial. BUTTONS .
If you do not want to change another button, turn the dial until
the display shows again
EXIT and push the Dial: READY .
In the same way you can change the Espresso, the Milk and the
Hot Water button
.
14.2 RESTORING FACTORY SETTINGS FOR BEVERAGE
BUTTONS
You can reset the beverage buttons back to the factory setting
as follows:
The machine is plugged in. Only the main power switch in the
back of the machine is on. The display is blank.
Example: reset the Espresso button.
• Open the cover of the Rotary Dial.
• Push and hold the Rotary Dial and then push the Espresso
button for two seconds. The display shows OK .
The factory setting (chapter 5) has been restored.
14.3 ENERGY SAVING MODE
You can set the machine to two different modes.
SAVE – The C9 OT is always ready to brew coffee and dispense
hot water. The C9 OT heats up for steaming/frothing for milk or
when preparing cappuccino.
SAVE ✓ Approx. 5 minutes after the last beverage was made,
the C9 OT switches to energy saving mode. When making coffee
at a later time, the C9 OT will first heat up for 5 to 30 seconds.
14.4 SETTING THE ACTUAL TIME
Setting the time allows you to program an "auto-on" time.
Example: Set the time to 7:15 AM.
• Push the Rotary Dial until the display shows
RINSE .
• Turn the Dial until the display shows TIME , push the Dial --.-- .
• Turn the Dial to select the hours 7:00 AM and push to confirm.
• Now turn the Dial to set the minutes: 7:15 AM .
• Push the Dial to confirm. OK , then TIME .
• Turn Dial to EXIT and push to get back to READY .
23.