Operation, Magic touch, Whirlpool switch – Jacuzzi U961000G User Manual

Page 15: Water level

ENGLISH

Magic Touch

Whirlpool Switch

The Magic Touch whirlpool ON/OFF switch, conven-

iently located on the bath, allows you to turn the whirl-
pool system on and off while in the bath. Simply push
down on the switch button to turn on the whirlpool sys-
tem. To turn the system off, push down on the button
again.

If your bath has an optional Jacuzzi Whirlpool Bath

wall mounted timer, set it for the amount of time you
wish the whirlpool to operate. NOTE: when you desire
less than 10 minutes of whirlpool action, it is necessary
to turn the timer knob clockwise past the number 10
and then back to the desired amount. If the whirlpool
action does not begin when the timer is correctly set, it
is necessary to push the Magic Touch switch button.

All baths manufactured by Jacuzzi Whirlpool Bath are

designed for "fill and drain," which means the bath should
be drained after each use and filled with fresh water by
the next bather. This is a health precaution, as these
baths are not designed to hold water continuously like
pools or spas. If you want a unit designed to continu-
ously hold water, see your Jacuzzi Whirlpool Bath dealer
for the complete line of whirlpool spas available.

Once the bath is installed, remove any residue or for-

eign materials left over from construction. Use turpen-
tine or paint thinner to remove stubborn stains, paint or
tar. Other dirt can be cleaned off with a mild liquid de-
tergent on a damp cloth. Scrape off plaster with a
wooden or plastic edge; do not use metal scrapers,
wire brushes or other metal tools, as they will dam-
age the bath's surface.

Water Level

Close the drain and fill the bath until water is at least

1" (25 mm) above the highest jet (see water line indi-
cated in the illustration). Do not turn on the whirlpool
system at any time if the jets are not completely im-
mersed in water. Running the whirlpool system when
there is insufficient water in the bath could result in wa-
ter spraying outside the bath area. Running the whirl-
pool system without water will damage the recirculating
pump.

MAGIC TOUCH

WHIRLPOOL

ON/OFF SWITCH

AIR
CONTROL
KNOBS (2)

DRAIN/OVERFLOW

FULLY ADJUSTABLE JETS

TYPICAL BATH FITTINGS

SUCTION
COVER

RLPOO

DEPRESS CENTER ON/OFF

MAGIC TOUCH SWITCH

PUSH

ON/OFF

OPERATION

FILL TO AT LEAST
1" ABOVE HIGHEST JET