Software installation – Jaton Communicator V.90 User Manual
Page 33
33
Check mark the Record a log file (ModemLog.txt in Windows®9x) for
diagnostic purpose.
Software Installation
Once the modem hardware installed and configured properly, you may use
the modem with any PC communication software. The bundled software
package is pre-configured for optimal performance with your modem.
Please refer to the software user’s guide for additional information.
If you are using an other communications software, please follows the
suggestions:
1. You must indicate to your communications software which COM Port
and IRQ has been assign to your modem.
2. Set the Data Rate to: 115.2 kbps. Do not select 28,800 or 14,400 bps as
serial port rates.
3. Set the Flow Control to: Hardware (or RTS/CTS)
4. Turn Auto Baud off (or Lock Baud Rate on)
5. Set Terminal Emulator to: ANSI