beautypg.com

Installation/connection manual, Preparations, Troubleshooting – JVC GET0483-001A User Manual

Page 137: Parts list for installation and connection, Installation, Removing the unit, Kd-s35, English, When using the optional stay, Removing the unit in dash-mounting

background image

KD-S35

Installation/Connection Manual
Manual de instalación/conexión

GET0563-002A

[J]

PREPARATIONS

You need the installation kits which corresponds to your car.
• Mark all the check boxes (

) to make sure you have follow the instructions and the listed parts.

Check the battery system in your car

Prepare this before installation

1

0508DTSMDTJEIN
EN, SP

© 2008 Victor Company of Japan, Limited

ENGLISH

ESPAÑOL

12 V DC, NEGATIVE ground

The fuse blows.
* Are the red and black leads connected correctly?

Power cannot be turned on.
* Is the yellow lead connected?

No sound from the speakers.
* Is the speaker output lead short-circuited?

Sound is distorted.
* Is the speaker output lead grounded?
* Are the “–” terminals of L and R speakers grounded in common?

Noise interfere with sounds.
* Is the rear ground terminal connected to the car’s chassis using shorter and thicker cords?

This unit becomes hot.
* Is the speaker output lead grounded?
* Are the “–” terminals of L and R speakers grounded in common?

This unit does not work at all.
* Have you reset your unit?

TROUBLESHOOTING

A

/

B

Hard case/
Control panel

C

Sleeve

D

Trim plate

E

Power cord

K

Handles

J

Rubber cushion

I

Mounting bolt—
M4 × 5 mm (M4 × 1/4");
M5 × 12.5 mm (M5 × 1/2")

H

Lock nut (M5)

G

Washer (ø5)

Parts list for installation and connection

L

Remote controller

M

Battery

When using the optional stay

Install the unit at an angle of
less than 30˚.

Screw (option)

Stay (option)

Fire wall

Dashboard

* Not supplied for this unit.

Flat type screws
—M5

× 8 mm (M5 × 3/8")*

Pocket

Flat type screws
—M5

× 8 mm (M5 × 3/8")*

Bracket

*

Bracket

*

Removing the unit

In dash-mounting

Before removing the unit, release the rear section.

When installing the unit without using the sleeve

In a Toyota car for example, first remove the car radio and install the unit in its place.

Do the required electrical
connections.

Bend the appropriate tabs
to hold the sleeve firmly
in place.

When you stand the unit, be careful
not to damage the fuse on the rear.

INSTALLATION

If you are not sure how to install this unit correctly, consult your JVC car audio dealer.

F

Direct connection
cable for iPod

Install_EN_KD-S35[J]_1.indd 1

Install_EN_KD-S35[J]_1.indd 1

6/5/08 4:41:33 PM

6/5/08 4:41:33 PM

This manual is related to the following products: