JVC SP-UXH100 - Manual (Page 9)

6
Getting Started
Unpacking
After unpacking, check to be sure that you have all the
following items.
The number in parentheses indicates the quantity of each
piece supplied.
• AM loop antenna (1)
• Remote control (1)
• Batteries (2)
If any item is missing, consult your dealer immediately.
Putting the Batteries into the Remote Control
Insert the batteries—R6(SUM-3)/AA(15F)—into the remote
control by matching the polarity (+ and –) on the batteries
with the + and – marking on the battery compartment.
When the remote control can no longer operate the unit,
replace both batteries at the same time.
• DO NOT use an old battery together with a new
one.
• DO NOT use different types of batteries together.
• DO NOT expose batteries to heat or flame.
• DO NOT leave the batteries in the battery
compartment when you are not going to use the
remote control for an extended period of time.
Otherwise, the remote control will be damaged
from battery leakage.
Connections
To connect speakers
You can connect the speakers using the speaker cords.
1 Hold the clamp of the speaker terminal.
2 Insert the end of the speaker cord into the
terminal.
Match the polarity of the speaker terminals: gray cord
(
ª) to red (ª) and gray cord with black stripe (·) to
black (
·).
3 Release your finger from the clamp.
IMPORTANT:
• Use only speakers with the same speaker impedance as
indicated by the speaker terminals on the rear of the unit.
• DO NOT connect more than one speaker to one
speaker terminal.
1
2
3
Gray
Gray with
black stripe
Speaker
cord Speaker
cord
Left speaker Right speaker
R6(SUM-3)/AA(15F)
Gray with
black stripe
Gray
1 2,3
LEFT
RIGHT
Continued
Do not connect the AC power cord until all other
connections have been made.
06-07_UX-H100[B].p65 04.2.24, 5:55 PM 6