JVC SP-UXH100 - Manual (Page 13)

10
On the remote control ONLY:
1
Tune in to the station you want to preset.
• See “Tuning in to a Station” on the left column.
2
Press PLAY MODE.
The preset number starts flashing on the
display.
• The PRGM (program) indicator lights up on the
display.
3
Press
¢ or 4 to select a
preset number.
You can also use the number button(s)
to select a preset number.
Ex.: For preset number 5, press 5.
For preset number 15, press +10,
then 5.
For preset number 20, press +10,
then 10.
For preset number 30, press +10,
+10, then 10.
4
Press PLAY MODE again.
5
To preset more stations, repeat steps 1 to 4
above, allocating a different preset number to
each station.
• Storing a new station on an already assigned number
erases the previously stored one.
When you unplug the AC power cord or if a power
failure occurs
The preset stations will remain in the unit.
Tuning in to a Station
1
Press FM/AM to select either “FM”
or “AM.”
The unit automatically turns on and tunes in to
the previously received station—either FM or AM (MW).
• Each time you press the button, the band alternates
between FM and AM (MW).
2
Press and hold
¢ or 4 (or
UP
¢ or DOWN 4 on the
unit) for more than 1 second.
• ¢ (UP ¢): Increases the frequencies.
• 4 (DOWN 4): Decreases the frequencies.
The unit starts searching for stations and stops when a
station of sufficient signal strength is tuned in.
• If an FM program is broadcast in stereo, the ST (stereo)
indicator lights up on the display (only when the
reception is good).
To stop during searching, press ¢ or 4 (or UP ¢ or
DOWN
4 on the unit).
When you repeatedly press ¢ or 4 (or UP ¢ or
DOWN 4 on the unit)
The frequency changes step by step.
To change the FM reception mode
On the remote control ONLY:
When an FM stereo broadcast is hard to receive or noisy,
press FM MODE so that the MONO indicator lights up on
the display. Reception will improve.
To restore the stereo effect, press FM MODE again so that
the MONO indicator goes off. In stereo mode, you can hear
stereo sound when a stereo program is broadcast.
• Changing the station also cancels the MONO mode.
Listening to FM and AM (MW) Broadcasts
FM/AM
Presetting Stations
You can preset 30 FM and 15 AM (MW) stations manually.
In some cases, test frequencies have been already stored
for the tuner since the factory examined the tuner preset
function before shipment. This is not a malfunction. You
can preset the stations you want into memory by following
the presetting method.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start again from step 2.
PRGM
PRGM
PLAY
MODE
1
4
7
10
2
5
8
+10
3
6
9
PLAY
MODE
Continued
10-11_UX-H100[B].p65 04.2.24, 5:56 PM 10