JVC GD-V422PCE - Manual (Page 6)

6
GD-V422PCE
GD-V502PCE
PLASMA DISPLAY
INPUT
SURROUND
VOL
N R
PICTURE SOUND SET UP
ASPECT PICTURE
POS. /SIZE
OFF TIMER PC
MULTI PIP SWAP SELECT MOVE ZOOM
Accessories
Accessories Supply
Check that you have the accessories and items shown
Requires two R6 batteries.
1. Turn the transmitter face down.
Press and slide off the battery
cover.
2. Install the batteries as shown in
the battery compartment.
(Polarity + or – must match the
markings in the compartment.)
3. Replace the cover and slide in
reverse until the lock snaps.
Helpful Hint:
For frequent remote control users, replace old batteries with
Alkaline batteries for longer life.
Precaution on battery use
Incorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter.
Observe the following precaution:
1. Batteries shall always be replaced as a pair. Always use new batteries when replacing the old set.
2. Do not combine a used battery with a new one.
3. Do not mix battery types (example: “Zinc Carbon” with “Alkaline”).
4. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.
5. Battery replacement is necessary when remote control acts sporadically or stops operating the Plasma Display.
Remote Control Batteries
Two “R6” size
AC cord
Fixing bands
Ferrite core
(small size)
×
1
Batteries for the Remote
Control Transmitter
(2
×
R6 Size)
Remote Control
Transmitter
EUR646532 Operating Instruction book
Ferrite core
(large size)
×
2
AC cord
(For UK only)