JVC VN-C30U - Manual (Page 9)

9
[Default Page Set-up] If “invalid”, it will be set to the regular VN-C30U
Top Page.
If “valid”, the HTML file you set will be used as
the default page.
*Default Page refers to the page that is displayed when only the IP address
is specified.
ATTENTION
Even if the function is “valid”, if the HTML file specified here does not
exist then a message such as “404: Not Found” will be displayed by the
browser when “http://192.168.0.2/” is specified, so make sure that the
setting is made correctly.
[HTTP Port] It is possible to change the port number of the
HTTP Server on this unit to a number other than
the default port 80 to raise the level of security.
(Selectable range: 1-65535 excluding 20 and 21)
If the HTTP Port is changed, access from web
browser will be done as follows:
h t t p : / / 1 9 2 . 1 6 8 . 0 . 2 : 1 2 3 4 5 / o r h t t p : / /
192.168.0.2:12345/index.html
(Example when Port 12345 is selected)
When you don’t know or forget the HTTP Port
number, use the provided Setup tool to check it.
[Default positioning] This enables setting the HTTP port automatically
in order to resume a specified position number
when the power is turned on or if the software is
reset. (It is necessary to register a position in
advance in the memory to enable this function.
Refer to page 19.)
CAUTION
• The allotted FTP user area is approximately 90 K bytes, however since
this unit’s file system is generated dynamically, the actual storable
capacity may be less than this in certain cases.
• Folders cannot be created on this FTP server. Only file upload/delete/
rename are possible.
03.10.17, 11:19 AM Page 9