JVC VN-C30U - Manual (Page 22)

22
Relay Alarm
When alarm signals are input one after another with an interval of a few seconds,
an interlocked alarm input can be identified and enable another operation.
[Enable/Disable] Check [Enable] to use the alarm output and [Disable]
to not use it.
[Configuration Items] These items are used to set the signal output from
the alarm output terminal.
• [Momentum]
Set the time period for which the alarm output is to
be continued.
• [Value]
Select whether the [High] or [Low] level signal is
output as the alarm output.
• [Power on Init]
Select whether or not the alarm signal is output from
the alarm output of VN-C30U at the moment it is
turned ON.
* Set the alarm output according to the output destination device.
* After completing alarm configurations, be sure to confirm that the alarm
operations are performed as intended.
Alarm Out
03.10.17, 11:20 AM Page 22