JVC RX-80PGD - Manual (Page 40)

Page 37
English
Using the On-Screen Display to Control the Receiver
You can use the menu function on the TV screen to control the receiver.
To use this function, you need to connect the TV to the MONITOR OUT jack on the rear panel (see page 9),
and set the TV’s input mode to the appropriate position to which the receiver is connected.
When the TV’s input mode is for TV, you cannot see the on-screen display.
IMPORTANT
When you use the menu functions, make sure that you have connected a TV and operate the
menu function while watching the on-screen displays on the TV.
Note:
If your TV is not of the PAL color system, the TV screen will be distorted.
Basic Procedures
From the remote control:
1. Press MENU SET.
The MAIN MENU appears on the TV screen.
• If you press
% / fi / @ / #, a sub-menu you can adjust at that time appears on the TV
screen instead of the MAIN MENU.
2. Press
% / fi to move
to the sub-menu you want to set, then press
@ / # .
The sub-menu you want appears.
3. If necessary, press
% / fi / @ / # to set or adjust the item you want on the selected sub-
menu.
When a item is selected, the item will be highlighted.
Note:
Moving
to an item does not mean that you have selected it. If the item is not highlighted,
press @ / # to highlight it.
4. When you finish, press MENU EXIT.
The menu disappears from the TV.
To go back to the MAIN MENU any time during the process
Press MENU SET again.
Selecting the Source to Play (Also see page 12)
1. Press MENU SET.
The MAIN MENU appears on the TV.
2. Press % / fi to move to “SOURCE,” then press @ / #.
The SOURCE menu appears.
3. Press % / fi to move to the source you want to play.
To select the DVD MULTI playback mode, press @ / # while “DVD” is selected as the
source.
4. When you finish, press MENU EXIT.
The menu disappears from the TV.
Adjusting the Front Speaker Output Balance (Also see page 15)
1. Press MENU SET.
The MAIN MENU appears on the TV.
2. Press % / fi to move to “SETTING,” then press @ / #.
The SETTING menu appears.
3. Press
% / fi to move
to “BAL.” (Balance).
4. Press @ / # repeatedly to adjust the balance.
5. When you finish, press MENU EXIT.
The menu disappears from the TV.
Menu function buttons
Shows the buttons you can use on the current menu. In
this case, press
% / fi to move up and down, and @
/ # to select the item.
MAIN MENU
Shows the buttons you can use on
the current menu.
In this case, press
% / fi to move
up and down, and @ / # to
adjust or set the item.
SETTING menu
SOURCE menu
O
N
SC
REEN CONT RO
L
MENU
EXIT
MENU
SET
TAPE VCR
CONTROL
EN37-43.RX-80P[UF]/f 98.8.31, 1:51 PM 37