English – JVC RX-80PGD User Manual

Page 30

Page 27

English

Using the DAP Modes

You can use five DAP modes — “Dance Club, Live Club, Hall, Pavilion, and Headphones.” These modes
(except “Headphones”) require the front speakers and the rear speakers, but do not require a center speaker
to enlarge the sound field.

Among the DAP modes, “Headphones” is very special. It can create the same stereo sound as you listen
through the speakers off air while listening to a source using headphones. So, you can feel as if you were not
using the headphones and listening to music in a room.

Note:
When you select “DVDMULTI” as the source to play, you cannot select the DAP mode.

On the front panel:

1. Press DAP/SURROUND MODE so that the Control

% / fi / @ / # buttons work for selecting

the DAP/surround modes.
The lamp next to the button lights up.

2. Press Control

@ / # to select the DAP mode.

The DAP indicator lights up on the display.
Each time you press the button, the DAP and surround modes alternately comes into effect.

3. Press Control

% / fi until the DAP mode you want appears on the display.

Each time you press the button, the DAP modes change as follows:

Dance CLUB:

Gives a throbbing bass beat.

Live CLUB:

Gives the feeling of a live music club with a low ceiling.

HALL:

Gives clear vocal and the feeling of a concert hall.

PAVILION:

Gives the spacious feeling of a pavilion with a high ceiling.

HeadPHONES*:

Gives a spacious stereo effect when listening with headphones.

DAP OFF:

No DAP mode is applied.

Note:
When you select “Headphones” (the

H.PHONE

indicator lights up), you cannot adjust the rear

speaker output level in the following steps.

4. Press DAP/SURROUND/DVD MULTI ADJUST so that the Control

% / fi / @ / # buttons work

for adjusting the selected mode.
The lamp next to the button lights up.

5. Press Control

% / fi until “– REAR +” appears on the display.

6. Press Control

@ / # to adjust the rear speaker output level.

• Pressing Control

@ decreases the output level up to –10 dB.

• Pressing Control

# increases the output level up to +10 dB.

Note:
You cannot adjust the left and right rear speaker output level separately.

7. Press Control

% / fi until “–EFFECT+” appears on the display.

8. Press Control

@ / # to adjust the effect level.

Each time you press the button, the effect level changes as follows:

As the number increases, the selected DAP mode becomes stronger.

Note:
When you select “Headphones” (the

H.PHONE

indicator lights up), you cannot select “EFFECT 5.”

To cancel the DAP mode, press Control

% / fi until “DAP OFF” appears in step 3 above.

The DAP indicator goes off from the display.