JVC RX-80PGD - Manual (Page 31)

Page 28
English
From the remote control:
1. Set the remote control mode selector to the “SOUND CONTROL” position.
10 keys are activated for adjusting the sounds.
2. Press DAP MODE until the DAP mode you want appears on the display.
The DAP indicator also lights up on the display.
Each time you press the button, the DAP modes change as follows:
Note:
When you select “Headphones” (the
H.PHONE indicator lights up), you cannot adjust the rear
speaker output level in the following steps.
3. Press REAR•(L) +/– to adjust the rear speaker output level.
• Pressing REAR•(L) – decreases the output level up to –10 dB.
• Pressing REAR•(L) + increases the output level up to +10 dB.
Note:
You cannot adjust the left and right rear speaker output level separately.
4. Press EFFECT to adjust the effect level.
Each time you press the button, the effect level changes as follows:
As the number increases, the selected DAP mode becomes stronger.
Note:
When you select “Headphones” (the
H.PHONE indicator lights up), you cannot select “EFFECT 5.”
To cancel the DAP mode, press DAP MODE until “DAP OFF” appears in step 2 above.
The DAP indicator goes off from the display.
REAR (L)
5 6
ENTER
Remote Control
EFFECT
7
/P
EFFECT 1 EFFECT 2
EFFECT 4
EFFECT 3
EFFECT 5
HALL L CLUB
PAVILION
D CLUB
H PHONES
(Live CLUB) (Dance CLUB)
(HeadPHONES)
DAP OFF
DAP MODE
0
FM MODE/MUTING
TV / VCR / TUNER
/ CD / DVD / VCD
SOUND
CONTROL
EN26-36.RX-80P[UF]/f 98.8.31, 1:48 PM 28