John Lewis JLDWS1202 - Manual (Page 22)

22
Starting a Dishwashing Cycle
1. Check that the spray arms can turn freely.
2. Turn the water tap on fully.
3. Press the ON/OFF button.
4. Select the desired cycle.
The programme indicator comes on. The remaining time expected for
the cycle will be shown in the multi-display.
3
During the dishwashing cycle, the remaining time shown in the multi-
display may be adjusted according to the size of the load, degree of
soiling, etc.
5. Close the door. The dishwashing cycle will begin.
A light signal in the form of a dot appears at floor level.
3
If the dishwasher is built in at high level with flush fitting cupboard
doors around it, the light signal cannot be seen.
The dot shaped light signal is not dangerous. (It is not a laser.) It lights
up while a dishwasher cycle is running and goes out when the cycle
ends.
Interrupting or Cancelling a Dishwashing Cycle
Only interrupt a dishwashing cycle that is in progress if it is absolutely
necessary.
Interrupting the dishwashing programme by opening the dishwash-
er door
1
Hot steam may escape when the door is opened. There is a risk of scald-
ing.
1. Open the door carefully. The dishwashing cycle will stop.
2. Close the door. The cycle will continue.
Cancelling the dishwashing cycle
1. Press function buttons 2 and 3 and keep them pressed.
The LED indicators of all the buttons that can be selected light up.
Exception: The 3in1 button will only illuminate if the function has been
activated.
2. Release the function buttons. The dishwashing cycle has been can-
celled.
3. If you want to start a new cycle, check whether there is any detergent
in the dispenser.
4. Switch off using the ON/OFF button.