JVC GR-DX106/76AG - Manual (Page 6)

EN
6
Automatic Demonstration takes place when
“DEMO MODE” is set to “ON” (factory-preset).
Ⅲ Automatic Demonstration starts when there is no operation for
about 3 minutes after the Power Switch @ is set to “ ” or “ ”
and no cassette is in the camcorder.
Ⅲ Performing any operation during the demonstration stops the
demonstration temporarily. If no operation is performed for
more than 3 minutes after that, the demonstration will resume.
Ⅲ “DEMO MODE” remains “ON” even if the camcorder power is
turned off.
Ⅲ To cancel Automatic Demonstration:
1. Set the Power Switch @ to “ ” while pressing down the
Lock Button $ located on the switch and press MENU 4 .
The Menu Screen appears.
2. Press + or – 5 to select “ (SYSTEM)” and press
SELECT/SET 3 .
3. Press + or – 5 to select “DEMO MODE” and press
SELECT/SET 3 . The Sub Menu appears.
4. Press + or – 5 to select “OFF” and press SELECT/SET 3 .
5. Press + or – 5 to select “ RETURN”, and press
SELECT/SET 3 twice. The normal screen appears.
NOTE:
If you do not detach the Lens Cap, you cannot see the actual changes of the Automatic Demonstration activated on
the LCD monitor or viewfinder.
AUTOMATIC DEMONSTRATION
None
RETURN
OF F
ON
EMO MODE D –
S Y S TEM
@ 3 $ 4 5
Sub Menu
Attach the Core Filter(s) to the provided AC Adapter’s cord, S-Video/Audio/Video/Editing cable and USB cable. The
Core Filter reduces interference.
HOW TO ATTACH THE CORE FILTER
1
Release the
stoppers on both
ends of the Core
Filter.
Ⅲ When connecting cables, attach the end with the Core Filter to the camcorder.
Stopper
3 cm
Wind
once
2
1) Run the cable through the Core Filter, leaving approx. 3 cm of cable between
the cable plug and the Core Filter.
If using the AC Adapter’s cord or USB cable, be sure to wind the cable once
around the outside of the Core Filter as shown in the illustration. Wind the
cable so that it is not slack.
NOTE: Take care not to damage the cable.
2) Close the Core Filter until it clicks shut.
3 cm
For the AC Adapter’s cord and USB cable
For the S-Video/Audio/Video/Editing cable
01 DX300,95,75AAGHS_EN 01-11 03.3.20, 6:14 PM 6