JVC TM-2100PN-K - Manual (Page 6)

6
PHASE CHROMA BRIGHT CONTRAST
INPUT SELECT
B A
Y/ C VIDEO VIDEO
Terminals on the rear panel
Video signal input Audio signal input
1 Input A
VIDEO A terminal AUDIO A terminal
(VIDEO)
2 Input B
VIDEO B terminal
AUDIO B terminal
(VIDEO)
3 Input B
VIDEO B (Y/C) terminal
(Y/C)
PAL
VOLUME : 20
PHASE : 00
+ –
INPUT
SELECT
button
Items
VOLUME/SELECT button
– +
PHASE
reddish greenish
(Phase)
CHROMA
lighter deeper
(Chroma)
BRIGHT
darker brighter
(Brightness)
CONTRAST
lower higher
(Contrast)
Colour system indication
(PAL or NTSC)
00 ~ 50
–20 ~ +20
HOW TO HANDLE BASIC
OPERATIONS
BASIC OPERATION
PICTURE ADJUSTMENT
1. Press the POWER switch to turn on the power.
_ON : Power turns ON. (Power indicator: lit)
—OFF : Power turns OFF. (Power indicator: unlit)
2. Press the INPUT SELECT button to choose input.
Selects video/audio signals input to terminals on the rear
panel.
3. Press the VOLUME/SELECT buttons to adjust the
speaker volume.
Press this button to display the speaker volume level on the
screen.
+ : The Built-in speaker volume is increased. (00
= 50)
– : The Built-in speaker volume is decreased. (50 = 00)
* Screen indication will disappear about 10 seconds after
operating.
1. Press select button corresponding to the item you
want to adjust.
The item you select is displayed on the screen.
1 PHASE ( ) : Phase control
2 CHROMA ( ) : Chroma control
3 BRIGHT ( ) : Brightness control
4 CONTRAST ( ) : Contrast control
VOLUME/SELECT
– +
* Screen indication will disappear about 10 seconds
after operating.
With regard to Colour system indication
● With the COLOR SYSTEM setting set
to AUTO mode, when you turn on the
power or select inputs, the colour
system indication appears for about 3
seconds on the screen while PAL or
NTSC signals are being detected.
It does not appear when receiving B/
W signal or when no signal is input.
See page 7 for COLOR SYSTEM
setting.
Notes:
● Phase control is effective only in the
NTSC colour system mode.
● Chroma control is not effective when
receiving B/W or when no signal is
input.
● When the Chroma control is set to
level “ –20”, the picture turns
monochrome.
● “ NO EFFECT” is displayed (For
about 3 seconds) when your selected
function has no effect.
2. Adjust with the VOLUME/SELECT buttons.
+ –
VOLUME/SELECT
– +
POWER
ON
OFF
LCT0054-002A-H 02.07.25, 3:44 PM 6